Gateway and Network Configuration
NOTE: It is recommended to set this after the first connect attempt has been made since the Preferred Server Name should be automatically available under normal conditions.
NetWare gateway configuration
In Gateways using the NetWare tab, the administrator can configure the NetWare Network automatically or manually. If the automatic mode is selected, a “wizard” steps the administrator through the configuration of the Novell Server and the NetWare Printer queues for the Xerox FreeFlow Print Server.
If the manual mode is selected, the interface enables manual entry and filtering for the Novell setups and printer queues.
LPD gateway configuration
In Gateways using the LPD (Line Printer Daemon) tab, the administrator can enable or disable the LPD protocol, set the default queue, and set the LPD port. The default port is 515, the most commonly used port.
Network configuration settings
Within the System Administration part of the user interface,
Network configuration options are presented.
IP configuration
In Network Configuration, using the IP Address tab, the administrator can enable or disable IP. If IP is enabled, the administrator can adjust or change the following settings:
•IP Address
•Host name
•Subnet mask
•Default gateway
The administrator must also select the IP Configuration Method. The drop down menu presents two options: a “Static” IP configuration which allows the user to specify the IP values, or “DHCP” method which allows a DHCP server to provide IP information.
NOTE: The user is prompted whenever a reboot is required.
System Guide | 1- 13 |