Getting Started
1
Replacing and
Storing Cartridges
22
Press the top cover release button to open the top cover so that it stands upright as shown.
Grip the end of the used cartridge and pull it out from the copier.
Remove the new cartridge from its shipping bag.
Hold the cartridge level so that the side with the written instructions is facing upward.
Rock the cartridge several times 90° to the right and left to evenly distribute the toner throughout the cartridge.
Peel the sealing tape grip from the end of the cartridge. Grasp the grip and pull the sealing tape out in the direction of the arrow mark away from the cartridge.
CAUTION:
When removing the sealing tape, take care not to allow the toner on the sealing tape to come into contact with your hands or clothing. If you get toner on either your hands or clothing, wash immediately with cold water. Washing with warm water will set the toner and make it impossible to remove.
MEMO:
The sealing tape is approximately 20” long. Be sure to pull the sealing tape completely out of the cartridge.
Hold the cartridge so that the side with the written instructions is facing to the left. Then, carefully insert the cartridge into the copier as far as it will go.