Main Menu (continued)
MOTOR COMMUNICATIONS
The MOTOR COMMUNICATIONS test is for use by the Customer Service Engineer only. However, user access is permitted in the event that Service instructs the user to perform this test. This test allows the Customer Service Engineer or user, if directed by the Service Engineer, to run a motor communications loopback test to assist in diagnosing a scanner problem.
When the Start key is press the message changes to STATUS:, then after the test completes either a PASS or FAIL status is displayed. If the status is FAIL, some test values will be displayed., and Service will be required.
DOCUMENT MOTOR
COMMUNICATIONS
PRESS START TO BEGIN
XES Synergix 8825/8830/8850/8855 Digital Solution User Guide | 107 |