XES Synergix 8825/8830/8850/8855 Digital Solution User Guide | 32 |
Making copies (continued)
Making a copy with the default settings
When the default document settings are used, the display indicates that the roll of media that best fits the size of the original document will be automatically selected. The reduction/ enlargement setting is 100%, so the copy will be the same size as the original document. The copy quantity is set to 1.
The illustration below shows the READY screen in its default state.
READY TO COPY
INSERT DOCUMENT
AUTO
100.0 1
NOTE: Many document settings other than the default settings are possible. For example, the options keys on the Scanner Control Panel allow you to control the media selection, image quality and reduction/enlargement percentage. The Transform special features key allows you adjust the margins around the image, specify the position of the image on the media, and transform the image into a mirror and/or inverted image. Refer to the applicable sections of this guide for detailed information about the many document settings available to you.
To make a copy using the default document settings:
1.Insert the original document face down and centered on the Document Feed Tray of the Scanner.
NOTE: If the document is not exactly centered and the AUTOCENTER feature is enabled, the Synergix Digital Solution will automatically correct the problem electronically. The resulting image will still be correctly positioned on the output media. If AUTOCENTER or AUTOWIDTH is disabled, you will need to carefully center the document when inserting it. Refer to "Controlling the scan" on the previous page.
2.Gently move the document forward until the lead edge engages the feed rolls. The Scanner transports the document to the starting position. It then scans the document. The resulting image is electronically sent to the Printer and your copy is printed.
NOTE: If AUTOSCAN is disabled, you will need to press the Start key to begin the scan. Refer to "Controlling the scan" on the previous page.
3.When the document is returned to the READY position, do one of the following:
•Pull the document to remove it. Lift the Thick Document Lever to remove fragile or thick documents.
•Press the Start key on the Scanner Control Panel to scan the document again.
NOTE: If DOCUMENT RETURN is set to REAR, the document is delivered to the rear Stacker. Some documents exit to the rear Stacker regardless of the DOCUMENT RETURN setting. Refer to "Controlling the scan" on the previous page.