12.Check for the following conditions to determine whether the adapter is working correctly and whether installation has been completed successfully:
vThe device driver files are loading successfully. There are no error messages.
vThe adapter LEDs indicate normal operation: Green ON, Amber OFF. See “Understanding the adapter LEDs and labels” on page 43.
If you experience problems, see “Chapter 4. Problem solving” on page 37.
OS/2 NDIS 2 device driver using MPTS
Use the following procedure to install the OS/2 NDIS 2 device driver using the
Multiple Protocol Transport Services (MPTS).
1.When updating an existing device driver, error message X100035, which indicates that the driver could not be installed and the previous version could not be restored, can be prevented by performing the following steps before beginning the update. This is particularly useful when the existing driver was installed from the adapter
v From an OS/2 window, go to the drive where OS/2 is installed. Change to the ibmcom subdirectory (where x is your drive letter):
x:
cd \ibmcom
vEnter the following two commands:
attrib
2.Start MPTS by performing either of the following actions:
vFrom the OS/2 desktop,
vFrom an OS/2 window, go into the ibmcom subdirectory and enter mpts at the OS/2 prompt.
3.Select OK on the MPTS logo panel.
4.Select Install. You will be prompted for the source of the .NIF file. Enter the path to the driver directory. Select OK once the Installation Complete message appears. You will return to the main menu.
5.Select Configure in the MPTS dialog box.
6.On the Configure panel, make sure that LAN adapters and protocols is preselected and then select Configure at the bottom of the panel.
7.In the Configuration panel, in the Network Adapters group box, select IBM
Note: You can edit parameter settings for this adapter. Highlight your adapter in the Current Configuration list box and select Edit.
8.In the Protocols list box, select the protocols used by your network application. Highlight each protocol and select ADD.
Note: If you are not sure which ones to use, select IBM IEEE 802.2 and IBM OS/2 NetBIOS protocol drivers or ask your network administrator.
The protocol drivers you have selected will appear under the adapter driver name in the Current Configuration list box.
Note: You can edit parameter settings for the protocols. Highlight a protocol and select Edit.