Note: You might need to reinstall the Service Pack due to changes to your services or protocols during installation.
12.Check for the following conditions to determine whether the adapter is working correctly and whether installation has been completed successfully:
vThe device driver files loaded successfully.
vThere are no error messages logged for the IBMTRP service in the Event Viewer.
vThe adapter LEDs indicate normal operation: Green ON, Amber OFF.
If you experience problems, see “Chapter 4. Problem solving” on page 37.
Windows 95
There are two different versions of Windows 95 in distribution: the retail release that individuals can purchase, and the OEM Service Release 2 (OSR2) that is found on most computer system preloads. To find out which release you are running, select Start → Settings → Control Panel, and then
vIf the number is 4.00.950a or 4.00.950, you are using the retail release of Windows 95.
vIf the number is 4.00.950 B, you are using the OSR2 release of Windows 95.
Make sure that you refer to the appropriate installation section for the version of
Windows 95 that you are using.
Before beginning installation, shut down the computer. Make sure that the operating system is correctly shut down and then switch off the power and disconnect the power cable from the power source.
Installing the driver when Windows 95 Retail is already installed
1.When you boot Windows 95, it will detect the new hardware and bring up a dialog box to allow a choice of drivers. Select Driver from disk provided by hardware manufacturer and then select OK.
2.Insert the
3.When prompted, enter the path to the driver directory and select OK.
Note: Some of the files on the diskette are located in the DOS subdirectory. If necessary, you will have to supply this subdirectory to get additional files copied onto your computer.
4.At this point, Windows 95 might prompt you for network names. Type your computer’s name and workgroup. Consult your system administrator if you do not know this information. Select OK to continue.
5.The driver files will be copied. Windows might prompt you for the Windows 95
After the files have been copied, a dialog box displays the following message:
To finish setting up your new hardware, you must
restart your computer. Do you want to restart your computer now?
6.Remove the diskette or
7.Check for the following conditions to determine whether the adapter is working correctly and whether installation has been completed successfully: