Fujitsu manual Primergy B120

Page 1

PRIMERGY B120

Intel-based Server Systems

OPERATING MANUAL

Image 1

Contents Primergy B120 Are there Page A26361-K646-Z102-1-7619 Operating Manual Primergy B120Page Contents Contents Introduction FeaturesSystem board Hard disk subsystemPower supply Introduction FeaturesService and Support High level of availability and failure protectionElectrical data standard power supply Technical dataNotational conventions IntroductionMechanical data StandardsEnvironmental conditions Noise levelInstallation and operation SafetyImportant notes Before operating the devicePoper operation of the system, warranty features Important notes SafetyBatteries Important notes CE certificateModules with electrostatic sensitive components Other important notesTransporting the server FCC Class B Compliance StatementEnvironmentally friendly product design and development Disposal and recyclingTake-back, recycling and disposal Further information on environmental protectionPage Installation steps InstallationUnpacking the server Setting up the tower server Instructions on connecting and disconnecting cablesInstallation Connecting cables125 240 Connecting the tower server to the line voltageConnecting the monitor to the line voltage Installing rack-server in/removing from rackMounting the slide-in module Installation Fitting spring nuts Installing the slide-in moduleMounting cage nuts Connecting the rack server to the line voltage Prepare the keyboard Installation Prepare the keyboardTower Rack Connecting devices to the serverConnecting devices to the server Preparation for use and operation Enabling access to the accessible drivesUnlocking/locking the tower server Preparation for use and operation Enabling access to the hard disk drivesOperation controls Drive indicators IndicatorsOperation controls Monitor screen Switching the server on and offServer is switched on Server is switched offOther switch-on methods Specified switch-on time/switch-off timeConfiguration with ServerStart Configuring the serverConfiguration without ServerStart Installing the operating systemFitting the hard disk cover Locking the tower serverLocking the server Cleaning the serverPage Opening and closing the tower server Opening and closing the serverOpening and closing the server Opening and closing the rack serverOpening and closing the rack server Page Property and data protection Page Operation indicator remains dark Troubleshooting and tipsServer switches itself off Screen stays blankFlickering stripes on the monitor screen Troubleshooting and tipsNo screen display or display drifts No mouse pointer displayed on the screen System does not bootFloppy disk cannot be read or written Time and/or date is not correctError messages on the screen Drives dead at system bootDisk Array Controller configuration is incorrect Added drive defectiveScsi hard disk subsystem System components and expansionsSystem components and expansions Scsi hard disk drivesRAID level 0 RAID level 1 and 5 without standby hard diskFunction of the indicators Green indicator Replacement of Scsi hard disk drive during operationOrange indicator Installing/removing a Scsi hard disk drive Scsi platter for four 1-inch hard disk slide-in modules IDE drive Accessible drivesScsi drive Open the server see Opening and closing the server Installing/Removing an accessible 5 ¼-inch driveChanging the floppy disk drive Removing/installing boards ChipDISK for RemoteView Installing/removing the chipDISKConfiguring the chipDISK Replacing the system fan System board Adapter modulePage ECC IndexKeyboard IndexSCSI-ID Troubleshooting and tips