Fujitsu B120 manual Opening and closing the server, Opening and closing the tower server

Page 41

5 Opening and closing the server

!

Please take note of the safety information in the chapter "Important notes".

ÊSwitch the server off.

!

Pull the power plug out of the power outlet.

ÊDisconnect all cables on the rear that are obstructing you.

5.1Opening and closing the tower server

	1
	4
2	3

ÊUnlock the server (1).

ÊUnscrew the two knurled screws (2).

ÊPush the side cover approx. 2 cm backwards (3).

ÊRemove the side cover sidewards (4).

ÊClosing is performed in the reverse order.

A26361-K646-Z102-1-7619

33

Image 41

Contents Primergy B120 Are there Page A26361-K646-Z102-1-7619 Operating Manual Primergy B120Page Contents Contents Introduction FeaturesSystem board Hard disk subsystemPower supply Introduction FeaturesService and Support High level of availability and failure protectionElectrical data standard power supply Technical dataNotational conventions IntroductionMechanical data StandardsEnvironmental conditions Noise levelInstallation and operation SafetyImportant notes Before operating the deviceBatteries Important notes SafetyPoper operation of the system, warranty features Important notes CE certificateModules with electrostatic sensitive components Other important notesTransporting the server FCC Class B Compliance StatementEnvironmentally friendly product design and development Disposal and recyclingTake-back, recycling and disposal Further information on environmental protectionPage Unpacking the server InstallationInstallation steps Setting up the tower server Instructions on connecting and disconnecting cablesInstallation Connecting cables125 240 Connecting the tower server to the line voltageConnecting the monitor to the line voltage Installing rack-server in/removing from rackMounting the slide-in module Installation Fitting spring nuts Installing the slide-in moduleMounting cage nuts Connecting the rack server to the line voltage Prepare the keyboard Installation Prepare the keyboardTower Rack Connecting devices to the serverConnecting devices to the server Unlocking/locking the tower server Enabling access to the accessible drivesPreparation for use and operation Preparation for use and operation Enabling access to the hard disk drivesOperation controls Operation controls IndicatorsDrive indicators Monitor screen Switching the server on and offServer is switched on Server is switched offOther switch-on methods Specified switch-on time/switch-off timeConfiguration with ServerStart Configuring the serverConfiguration without ServerStart Installing the operating systemFitting the hard disk cover Locking the tower serverLocking the server Cleaning the serverPage Opening and closing the tower server Opening and closing the serverOpening and closing the server Opening and closing the rack serverOpening and closing the rack server Page Property and data protection Page Operation indicator remains dark Troubleshooting and tipsServer switches itself off Screen stays blankNo screen display or display drifts Troubleshooting and tipsFlickering stripes on the monitor screen No mouse pointer displayed on the screen System does not bootFloppy disk cannot be read or written Time and/or date is not correctError messages on the screen Drives dead at system bootDisk Array Controller configuration is incorrect Added drive defectiveScsi hard disk subsystem System components and expansionsSystem components and expansions Scsi hard disk drivesRAID level 0 RAID level 1 and 5 without standby hard diskOrange indicator Replacement of Scsi hard disk drive during operationFunction of the indicators Green indicator Installing/removing a Scsi hard disk drive Scsi platter for four 1-inch hard disk slide-in modules Scsi drive Accessible drivesIDE drive Open the server see Opening and closing the server Installing/Removing an accessible 5 ¼-inch driveChanging the floppy disk drive Removing/installing boards ChipDISK for RemoteView Installing/removing the chipDISKConfiguring the chipDISK Replacing the system fan System board Adapter modulePage ECC IndexKeyboard IndexSCSI-ID Troubleshooting and tips