chipDISK for RemoteView | System components and expansions |
1 |
ÊScrew the chipDISK onto the side of the drive cage (1).
ÊConnect the IDE data cable provided to the chipDISK (1) and to the primary IDE interface of the system board.
ÊConnect the other end of the power supply cable to the appropriate connection on the system board. (see also the technical manual for the system board).
ÊClose the server again (see "Opening and closing the server").
Removing is performed in the reverse order.
8.4.2 Configuring the chipDISK
You must enter the chipDISK parameters (hard disk parameters) in BIOS Setup and boot from the chipdisk once using these parameters in order for RemoteView to be started automatically later. Proceed as follows:
ÊReboot the server.
ÊPress the function key [F2] if the message Press <F2> to enter Setup is displayed on the screen.
ÊIn the
ÊSet the value for Type to Auto.
ÊSelect the Server menu in the BIOS setup.
ÊSet the value for Diagnostic System to enabled. Change the setting for Next Boot Uses to
Diagnostic System.
ÊSave the setting and terminate BIOS Setup.
The server boots
If the RemoteView software is not yet installed on the chipDISK, install the software as
i described in the manual for RemoteView.
ÊTo terminate RemoteView, use the menu item Boot Original OS.
The server boots the standard operating system. How to operate RemoteView is described in the corresponding documentation of RemoteView.
53 |