Fujitsu B120 manual Installation Prepare the keyboard

Page 28

Installation

Prepare the keyboard

2

1

ÊPlug the power cable of the server into the server (1) and into a free electrical outlet of the multi-outlet assembly in the rack (2) (see technical manual for rack).

Guide the cable through the cable routings of the rack.

3.6Prepare the keyboard

ÊPlug the appropriate connector of the keyboard cable into the socket on the underside of the keyboard as shown in the illustration above.

20	A26361-K646-Z102-1-7619

Image 28

Contents Primergy B120 Are there Page A26361-K646-Z102-1-7619 Primergy B120 Operating ManualPage Contents Contents Features IntroductionSystem board Hard disk subsystemIntroduction Features Power supplyService and Support High level of availability and failure protectionTechnical data Electrical data standard power supplyNotational conventions IntroductionStandards Mechanical dataEnvironmental conditions Noise levelSafety Installation and operationImportant notes Before operating the devicePoper operation of the system, warranty features Important notes SafetyBatteries CE certificate Important notesModules with electrostatic sensitive components Other important notesFCC Class B Compliance Statement Transporting the serverDisposal and recycling Environmentally friendly product design and developmentTake-back, recycling and disposal Further information on environmental protectionPage Installation steps InstallationUnpacking the server Instructions on connecting and disconnecting cables Setting up the tower serverInstallation Connecting cablesConnecting the tower server to the line voltage 125 240Installing rack-server in/removing from rack Connecting the monitor to the line voltageMounting the slide-in module Installation Installing the slide-in module Fitting spring nutsMounting cage nuts Connecting the rack server to the line voltage Installation Prepare the keyboard Prepare the keyboardConnecting devices to the server Tower RackConnecting devices to the server Preparation for use and operation Enabling access to the accessible drivesUnlocking/locking the tower server Enabling access to the hard disk drives Preparation for use and operationOperation controls Drive indicators IndicatorsOperation controls Switching the server on and off Monitor screenServer is switched off Server is switched onOther switch-on methods Specified switch-on time/switch-off timeConfiguring the server Configuration with ServerStartConfiguration without ServerStart Installing the operating systemLocking the tower server Fitting the hard disk coverCleaning the server Locking the serverPage Opening and closing the server Opening and closing the tower serverOpening and closing the rack server Opening and closing the serverOpening and closing the rack server Page Property and data protection Page Troubleshooting and tips Operation indicator remains darkServer switches itself off Screen stays blankFlickering stripes on the monitor screen Troubleshooting and tipsNo screen display or display drifts System does not boot No mouse pointer displayed on the screenFloppy disk cannot be read or written Time and/or date is not correctDrives dead at system boot Error messages on the screenDisk Array Controller configuration is incorrect Added drive defectiveSystem components and expansions Scsi hard disk subsystemScsi hard disk drives System components and expansionsRAID level 0 RAID level 1 and 5 without standby hard diskFunction of the indicators Green indicator Replacement of Scsi hard disk drive during operationOrange indicator Installing/removing a Scsi hard disk drive Scsi platter for four 1-inch hard disk slide-in modules IDE drive Accessible drivesScsi drive Installing/Removing an accessible 5 ¼-inch drive Open the server see Opening and closing the serverChanging the floppy disk drive Removing/installing boards Installing/removing the chipDISK ChipDISK for RemoteViewConfiguring the chipDISK Replacing the system fan Adapter module System boardPage Index ECCIndex KeyboardSCSI-ID Troubleshooting and tips