|
8.1.2Installing/removing the hot-plug power supply unit
1
1
2
2
Figure 17: Unlocking and installing the power supply unit
ÊFold down the locking lever (1) and slide the power supply unit into the mounting location (2) as far as it will go.
The locking lever will turn upwards and engage.
ÊCheck that the locking lever is properly locked in place. If necessary, push the lever up.
ÊConnect the power supply unit to the mains (see section “Connecting the server to the mains” on page 47).
To remove the server, follow this procedure in reverse.
RX330 S1 | Operating manual | 71 |