Chapter 4 Installing the Internet Streamer CDS Software and Initially Configuring a CDE
Running the BIOS Setup Utility
Figure 4-10 Exit Options Screen
Step 15 Ensure that the CD with the CDS image is in the internal
The system boots from the image on the CD. This requires a terminal server to be hooked up to the serial port of the CDE100. All communication is done through the serial port (see the “Before You Begin” section on page
Once the CD starts booting, it displays a spinning “” symbol for approximately five minutes. Allow the booting to proceed and monitor the sequence from a remote terminal provided by the terminal server.
The CD boot menu is displayed at the conclusion of this boot sequence:
Welcome to the installer. The installer enables installation of a new software image onto your system, or recovers a previous image in the event that the hardware was changed.
MODEL: CDE100
FLASH: found, directory validated
COOKIE: valid
IMAGE:
FLASHDEV: /dev/hdX
Installer Main Menu:
1.Configure Network
2.Manufacture flash
3.Install flash cookie
4.Install flash image from network
5.Install flash image from cdrom
6.Install flash image from disk
7.Wipe out disks and install.bin image
8.Exit (and reboot)
9.Force manufacturing flash
Choice [0]:
Step 16 Confirm that the FLASHDEV: line near the top of the menu displays something similar to “/dev/hdX”, where “X” can be any letter.
a.If no flash device is found, choose Option 8 to exit and reboot, and enter the BIOS Setup menu again. Confirm that the BIOS detected the flash device.
b.If the BIOS detects the
www.cisco.com/techsupport
Cisco Content Delivery Engine 100/200/300/400 Hardware Installation Guide
|
| |
|