Cisco Systems 100/200/300/400 specifications Document Revision History, Document Organization

Page 7

Preface

This preface describes the objectives and organization of this guide and contains the following sections:

Document Revision History, page vii

Document Organization, page vii

Objectives, page viii

Audience, page viii

Related Documentation, page viii

Conventions, page ix

Safety Information Referral Warning, page ix

Obtaining Documentation and Submitting a Service Request, page xv

Document Revision History

The Document Revision History table below records technical changes to this document.

Document Version

Date

Change Summary

 

 

 

OL-13478-02

March 28, 2008

Added CDE300 and CDE400 to this document.

 

 

 

OL-13478-01

August 20, 2007

This is the first version of this document.

 

 

 

Document Organization

 

 

Chapter

Description

 

 

 

 

 

 

 

 

Chapter 1, “Overview of the Content Delivery

Provides a brief introduction to the Content

 

 

Engines”

Delivery Engines (CDEs).

 

 

 

 

 

 

 

Chapter 2, “Preparing to Install the Content

Contains site requirements and important safety

 

 

Delivery Engines”

information for working with the CDEs

 

 

 

 

 

 

 

Chapter 3, “Installing the Content Delivery

Provides the necessary information to properly

 

 

Engines”

install the CDS hardware components.

 

 

 

 

 

 

 

 

 

 

Cisco Content Delivery Engine 100/200/300/400 Hardware Installation Guide

 

 

 

 

 

 

 

 

 

 

 

 

 

 

OL-13478-03

 

 

vii

 

 

 

 

 

Image 7
Contents Americas Headquarters MarchCisco Systems, Inc. All rights reserved N T E N T S Connecting Network Cables Ethernet Connector Pin Assignments B-2 OL-13478-03 Document Organization Document Revision HistoryDate Change Summary Chapter Description ObjectivesAudience Related DocumentationCisco Internet Streamer CDS 2.x Product Documentation Conventions Safety Information Referral WarningAvvertenza Importanti Istruzioni Sulla Sicurezza Warnung Wichtige SicherheitshinweiseAviso Instruções Importantes DE Segurança TA Vare PÅ Disse InstruksjoneneXii GEM Disse Anvisninger Xiv Obtaining Documentation and Submitting a Service Request Xvi Cisco Internet Streamer CDS Overview Overview of the Content Delivery EnginesOnDemand Application Cisco TV CDS OverviewVideo Accelerator Software CDE200 Front View Hardware FeaturesEth5 eth3 Processor Memory Drives Rack Unit EthernetInterface Processor Memory Drives GE Ports Interface Control Buttons10 CDE200 Front Panel Control Buttons 12 CDE400 Back Panel Control Buttons LED IndicatorsColor State Description LED15 CDE300 Front Panel LEDs 17 CDE100 Connector Locations Input/Output Ports and ConnectorsCDE200 Connector Locations CDE400 Connector Locations OL-13478-03 Preventing Electrostatic Discharge Damage Site RequirementsEnvironmental, Physical, and Power Specifications Safety Warnings OL-13478-03 Page General Precautions Safety GuidelinesAC Power Option Warnings DC Power Option WarningsProtecting Against Electrostatic Discharge Intended Uses Safety InformationIf AC Power Supplies Are Installed Emissions DisclaimerAmps Statement If DC Power Supplies Are InstalledTemperature and Ventilation Server Types Installing the Content Delivery EnginesUnpacking the Box Tools and Parts RequiredInstalling the CDEs Verifying ContentsInspecting for Damage Preparing the CDEs for Rack Installation Making Physical Connections Installing CDEs in the RackConnecting Power Cords CDE300 SX Version Connector Locations Connecting Network Cables Interface Switch Port Mbps Installing or Removing Disk DrivesCDE400 Disk Drive Locations Statement 11 Disk Drive Tray Installation and Removal Before You Begin Ethernet Stream Running the Bios Setup UtilityInstallation and Configuration Order Ethernet Management Gigabit Ethernet Ports Management PortsRunning the Bios Setup Utility for the CDE100 Boot Settings Menu Boot Device Priority Screen Advanced Settings Menu Set the Serial Port2 Address option to Disabled 10 Exit Options Screen Running the Bios Setup Utility for the CDE200 Set the QuickBoot Mode option to Enabled 14 Hard Disk Drives Screen Set the Com Port Address option to On-board COM a Model CDE200 Installing the SoftwareAssigning the Primary Interface Initially Configuring a CDEVerifying the Cdsm Running the Setup Utility18 Cdsm Login Documentation section on OL-13478-03 Troubleshooting Ethernet Adapters Hardware TroubleshootingTroubleshooting Sata Drives Specifications Technical SpecificationsCDE200 CDE100CDE400 CDE300Data Rate ManagementInput Cables Description Pin Serial Console Interface Connector Pin AssignmentsSerial Port Connector Ethernet Connector Pin AssignmentsPin T568B 100BASE-T Signal Ethernet Port ConnectorRJ-45 Pin End Wire Color Diagram End Computer Cable Pin AssignmentsWhite/Orange White/Green Blue White/Blue White/Brown OL-13478-03 Processor WeightFan Assembly Management InterfaceTransport Content Storage CapacityIngest Interface Stream InterfacesCDE200 IBM Cached Content CapacityEthernet Interfaces Scsi Controllers Figure C-1shows the location of all connectors for a CDE100 Connector Pin AssignmentsFigure C-3 CDE200 IBM Connector Locations Eth1 Eth0 Eth3 eth5 Eth6 Eth5 Eth8 Eth2 Eth4 Eth7 Eth1 Eth3 DC Power Overview Connecting DC PowerFigure D-2 CDE200 Rear Panel Connecting DC Power to a CDE200Star washer PM ground ring lug Nut Connecting DC Power to a CDE200 section on page D-2 Disconnecting Power and Replacing a PM on a CDE200Figure D-5 CDE300 Rear Panel Connecting DC Power to a CDE300Figure D-6 CDE300 Building/PM Ground Stud Order Disconnecting Power and Replacing a PM on a CDE300 Connecting DC Power to a CDE40048 VDC Figure D-8 CDE400 PM Ground Stud Order Disconnecting Power and Replacing a PM on a CDE400 DC Power Cable Connector and Pinouts OL-13478-03 Numerics IN-2 IN-3 IN-4 IN-5 IN-6