Chapter 4 Installing the Internet Streamer CDS Software and Initially Configuring a CDE
Verifying the CDSM
Running the Setup Utility
Use the Setup utility to configure the network settings and register the CDEs with the CDSM.
Step 1 Enter the following commands to run the Setup utility:
CDE# setup CDE#
What is the mode of the device (SE/SR/CDSM) [SE]: SE
Is this SE going to be managed by a CDSM (Content Delivery System Manager) (y/n) [y]:y Please choose an interface to configure from the following list:
1:GigabitEthernet 1/0
2:GigabitEthernet 2/0
3:GigabitEthernet 3/0
4:GigabitEthernet 4/0
5:GigabitEthernet 5/0
6:GigabitEthernet 6/0
Enter choice: 1 |
| |
Do you | want to enable DHCP on this interface (y/n) [n]: n | |
Please | enter the | IP address of this interface: 209.165.200.255 |
Please | enter the | netmask of this interface: 255.255.255.244 |
Please | enter the | default gateway: 10.0.0.0 |
Please | enter the | domain name server ip: 172.16.0.0 |
Please | enter the | domain name: spcdn.com |
Please | enter the | hostname: CDStr1 |
Please | enter CDSM (Content Delivery System Manager) IP or Host name: 209.165.201.0 | |
Press any key to | continue | |
CDE# configure terminal
CDE# cms enable
This process initiates database services on the device that you just configured.
Note Once the IP default gateway has been set, we recommend you ping the outside network to verify it is reachable. Then verify that the CDSM is reachable.
Step 2 After you have run the Setup utility on each SE or SR, they register with the CDSM. Save the configuration by entering the following command:
CDE# copy
Verifying the CDSM
Perform the following steps to verify that the CDSM is operational:
Step 1 Launch a web browser and enter the CDSM IP address. The CDSM Login page appears (see Figure
|
| Cisco Content Delivery Engine 100/200/300/400 Hardware Installation Guide |
|
| |
|
|
| |||
|
|
|
| ||
|
|
|
| ||