Tripp Lite SMART2600RM2U, SMART3000RM2UP, SMART3000RMXL2U Quick Installation, Turn the UPS on

Quick Installation

1Plug the UPS into an outlet on

a dedicated circuit.

NOTE! after you plug the UPS into a live AC outlet, the UPS (in “Standby” mode) will automatically charge its batteries, but will not supply power to its outlets until it is turned ON.

1

2 Plug your equipment into the UPS.*

* Your UPS is designed to support only electronic
equipment. You will overload the UPS if the total
VA ratings for all the equipment you connect
exceeds the UPS’s Output Capacity. To find your
equipment’s VA ratings, look on their
nameplates. If the equipment is listed in amps,
multiply the number of amps by 120 to	2
determine VA. (Example: 1 amp × 120 = 120

VA). If you are unsure if you have overloaded the UPS’s outlets, see LOAD icon description in LCD Interface section under Basic Operation.

3 Turn the UPS ON.

Press and hold the button A for one second. The alarm will beep once briefly.

Note: UPS system will function properly upon initial startup, however, maximum runtime and a successful self-test will only be accessible after it has been charged for 24 hours.

3

6

A

12-12-037-93-3088-B.indb 6 12/26/2012 3:47:25 PM