Tripp Lite 20KVA owner manual Model SU30K3/3INT

Page 19

Specifications (continued)

Model: SU30K3/3INT

Input

Input Voltage

220/380, 230/400, 240/415V,

 

3ø, 4 Wire (plus ground), wye

Input Frequency

50/60 Hz ± 3 Hz (auto-selectable)

Voltage Correction Range

156-280/270-485V AC

Input Current (Per Phase, On-Line)

45A/43A/41A

Inrush Current

<300A

Power Factor (Full Load)

>0.95

Efficiency (Full Load/On-Line)

>91%

Circuit Breaker

63A (3p)

Input Bypass Circuit Breaker

63A (3p)

 

 

Output

 

VA

30000

Watts (Power Factor: 0.8)

24000

Waveform (On-Line)

Sinewave

Waveform (On-Battery)

Sinewave

Output Voltage (RMS)

User-selectable 220/380, 230/400,

 

240/415V AC, 3ø, 4 Wire (plus ground), wye

Output Frequency

50/60 Hz (auto-selectable)

 

(± 0.1 Hz on battery)

Voltage Regulation

±2%

Max. Harmonic Distortion

 

(Non-Linear Full Load)

<5%

Overload Capabilities

<102% (continuous), 102%~125% (1 min.),

 

125%~150% (30 sec.), >150% (2 sec.)

Short Circuit Capability

>250A

Crest Factor

3:1

 

 

Battery

 

Battery Type

Sealed, Lead Acid, 240V DC, 9AH

Battery Pack Quantity

Three Packs (20 12V DC Batteries per pack)

Protection

Six UL- or IEC- recognized 30A 600VDC

 

rated cartridge fuses (two per battery pack)

 

and fuse block (1 per battery pack)

Typical Backup Time (Half Load) 13 min. +

Typical Backup Time (Full Load) 5 min. +

Operation

On-Line Transfer Time

(Line to Battery, Battery to Line) 0 ms

Audible Noise (Full Load @ 1 meter) <65 dBA

Indicators

Includes an LCD Display and LEDs (AC Line In, Bypass Line In, AC to DC, DC to AC, AC Output, Battery Back-Up, Bypass).

Communications

Includes an RS-232 DB9 female connector, an AS-400 DB9 female connector, a dry contact DB9 female connector and an accessory slot.

Connections

Input Terminal Block

100A

Output Terminal Block

100A

 

 

Physical Specifications

 

Unit Dimensions (H x W x D)

35.3 x 19.3 x 36 in. (89.7 x 49 x 91.4 cm)

Unit Weight

662 lb. (300 kg)

Shipping Dimensions (H xW x D) 43 x 28 x 44.5 in. (109.2 x 71.1 x 113 cm)

Shipping Weight

750 lb. (340 kg)

Model: SU30K3/3INTXR5

Input

Input Voltage

220/380, 230/400, 240/415V AC,

 

3ø, 4 Wire (plus ground), wye

Input Frequency

50/60 Hz ± 3 Hz (auto-selectable)

Voltage Correction Range

156-280/270-485V AC

Input Current (Per Phase, On-Line)

45A/43A/41A

Inrush Current

<300A

Power Factor (Full Load)

>0.95

Efficiency (Full Load/On-Line)

>91%

Circuit Breaker

63A (3p)

Input Bypass Circuit Breaker

63A (3p)

 

 

Output

 

VA

30000

Watts (Power Factor: 0.8)

24000

Waveform (On-Line)

Sinewave

Waveform (On-Battery)

Sinewave

Output Voltage (RMS)

User-selectable 220/380, 230/400,

 

240/415V AC, 3ø, 4 Wire (plus ground), wye

Output Frequency

50/60 Hz (auto-selectable)

 

(± 0.1 Hz on battery)

Voltage Regulation

±2%

Max. Harmonic Distortion

 

(Non-Linear Full Load)

<5%

Overload Capabilities

<102% (continuous), 102%~125% (1 min.),

 

125%~150% (30 sec.), >150% (2 sec.)

Short Circuit Capability

>250A

Crest Factor

3:1

 

 

Battery

 

Battery Type

Sealed, Lead Acid, 240V DC, 9AH

Battery Pack Quantity

Five Packs (20 12V DC Batteries per pack)

Protection

Ten UL- or IEC- recognized 30A 600VDC

 

rated cartridge fuses (two per battery pack)

 

and fuse block (1 per battery pack)

Typical Backup Time (Half Load) 25 min. +

Typical Backup Time (Full Load) 11 min. +

Operation

On-Line Transfer Time

(Line to Battery, Battery to Line) 0 ms

Audible Noise (Full Load @ 1 meter) <65 dBA

Indicators

Includes an LCD Display and LEDs (AC Line In, Bypass Line In, AC to DC, DC to AC, AC Output, Battery Back-Up, Bypass).

Communications

Includes an RS-232 DB9 female connector, an AS-400 DB9 female connector, a dry contact DB9 female connector and an accessory slot.

Connections

Input Terminal Block

100A

Output Terminal Block

100A

 

 

Physical Specifications

 

Unit Dimensions (H x W x D)

48.5 x 19.3 x 36 in. (123.2 x 49 x 91.4 cm)

Unit Weight

935 lb. (424 kg)

Shipping Dimensions (H xW x D) 61.5 x 31 x 44.5 in. (156.2 x 78.7 x 113)

Shipping Weight

1152 lb. (523 kg)

+ Backup times are expandable with additional Battery Packs, sold separately. The policy of Tripp Lite is one of continuous improvement. Specifications are subject to change without notice.

Regulatory Compliance Identification Numbers

For the purpose of regulatory compliance certifications and identification, your Tripp Lite product has been assigned a unique series number. The series number can be found on the product nameplate label, along with all required approval markings and information. When requesting compliance information for this product, always refer to the series number. The series number should not be confused with the marking name or model number of the product.

19

Image 19
Contents Español Français UPS Location Warnings Important Safety WarningsControl Panel Front PanelBattery Access Panel cover removed Rear Panel Rear PanelUPS Location InstallationMounting Bracket Installation UPS Input and Output Hardwire ConnectionOutput Voltage Selection VIA Software Initial Battery ChargingWiring Connection Operation Normal ConditionsLCD Display Select Button SELF-TESTINGSelf Testing Battery OK DC to DC OK Inverter Test Turning the UPS OFFOperation Under Shutdown Operation Special ConditionsOperation on BYPASS-VOLTAGE OUT of Range Inverter on WarningsCommunications Open Remote Emergency Power OFF EPODRY Contact Interface DRY Contact Interface TableAdding or Replacing Internal Batteries Do not Remove Battery SleeveBattery Packs are Heavy Check Battery Pack Voltage Before Completing InstallationInternal Battery Pack Wiring Diagram Adding or Replacing Internal Batteries Adding or Replacing Internal Batteries Adding or Replacing Internal Batteries Observe Proper Polarity ServiceWarranty Limited WarrantyModel SU20K3/3INT SpecificationsModel SU30K3/3INT Manual del Propietario Advertencias sobre la colocación y ubicación del UPS Advertencias de Seguridad ImportantesPanel DE Control Panel FrontalPanel DE Acceso a LA Bateria Tapa Removida Panel Frontal continuaciónPanel Trasero Panel TraseroConexion a Tierra InstalaciónUbicación DEL UPS Instalacion DE LOS Soportes DE MontajeEncendiendo EL UPS Operación Condiciones NormalesCarga Inicial DE LA Bateria Seleccion DEL Voltaje DE Salida VIA SoftwareBoton Select Seleccionar DE LA Pantalla LCD Operación Condiciones Normales continuaciónApagando EL UPS AUTO-PRUEBAOperacion Bajo CIERRE/PARADA Operación Condiciones EspecialesOperacion EN DERIVACION-VOLTAJE Fuera DE Rango Advertencias DEL Inversor EncendidoComunicaciones Operación Condiciones Especiales continuaciónTabla DE LA Interfaz DE Contacto Seco Comunicaciones continuaciónInterfaz DEL Contacto Seco Apagado DE Emergencia Remoto EPO¡NO Remueva LA Cubierta Protectora DE LA Bateria Añadiendo o Remplazando las Baterías Internas¡LOS Modulos DE Bateria SON Pesados Añadiendo o Remplazando las Baterías Internas continuación Diagrama DEL Cableado DEL Modulo DE Baterias InternasAñadiendo o Remplazando las Baterías Internas continuación Terminales ¡PELIGRO ¡OBSERVE LA Polaridad Correcta ServicioGarantía Garantia LimitadaModelo SU20K3/3INT EspecificacionesModelo SU30K3/3INT Especificaciones continuaciónManuel du propriétaire Mises en garde relatives à la localisation de londuleur Importantes consignes de sécuritéPanneau avant Panneau DE CommandePanneau Daccès AUX Batteries carter enlevé Panneau avant suitePanneau Arrière Panneau arrièreSélection DU Câblage IL Faut Installer Londuleur À Laide DE Brides DE FixationMises EN Garde Relatives À LA Localisation DE Londuleur Connexion DE Mise À LA TerreSélection DE LA Tension DE Sortie À Laide DUN Logiciel Installation suiteFonctionnement Conditions normales Première Charge DE LA BatterieBouton DE Sélection DE Lécran ACL Fonctionnement Conditions normales suiteArrêter Londuleur Éxécution DUN AUTO-TESTFonctionnement Pendant UN Arrêt Fonctionnement Conditions spécialesFonctionnement EN DÉRIVATION-TENSION Hors Plag Mises EN Garde Inverseur EN MarcheInterface RS-232 Commuter Londuleur EN Mode NormalFonctionnement Conditions spéciales suite Fonctionnement DU Commutateur DE Dérivation ManuelleInterface Contact SEC Ajout et remplacement des batteries internesArrêt Durgence Emergency Power OFF EPO À Distance Communications suiteSchéma DU Câblage Interne DUN Bloc DE Batterie Ajout et remplacement des batteries internes suiteAjout et remplacement des batteries internes suite Bornes Ajout et remplacement des batteries internes suite Garantie Limitée À VIE GarantieObserver LA Bonne Polarité Modèle SU20K3/3INT SpécificationsModèle SU30K3/3INT Spécifications suite