Tripp Lite 20KVA owner manual Service, Limited Warranty, Observe Proper Polarity

Page 17

Adding or Replacing Internal Batteries (continued)

WARNING!

OBSERVE PROPER POLARITY!

Connect BLACK-to-BLACK and RED-to-RED. Failure to observe proper polarity will cause permanent damage to the UPS System and create a potential for serious personal injury.

13

14

15

16

Connect the BLACK cable for each internal battery pack to the nearest BLACK connector located inside the UPS system's battery module.

Connect the RED cable for each internal battery pack to the nearest RED connector located inside the UPS system's battery module.

Replace the battery access panel.

Return the UPS System to Normal Mode or completely turn it on, depending on the procedure you followed in step 1. See “Operation of Manual Bypass Switch” or “Turning the UPS On” in the Operation section.

13 / 14

Service

Your SmartOnline 3-Phase UPS System is covered by the limited warranty described below. Extended warranty (2-, 3- and 4-year) and start-up service programs are available. For more information, call Tripp Lite Customer Service at (773) 869-1234.

Warranty

LIMITED WARRANTY

Seller warrants this product, if used in accordance with all applicable instructions, to be free from original defects in material and workmanship for a period of 2 years (except U.S., Canada and Mexico: 1 year) from the date of initial purchase. If the product should prove defective in material or workmanship within that period, Seller will repair or replace the product, in its sole discretion. Service under this Warranty includes parts and Tripp Lite service center labor. Onsite service plans are available from Tripp Lite through authorized service partners (in most areas). Contact Tripp Lite Customer Service at (773) 869-1234 for details. International customers should contact Tripp Lite support at intlservice@tripplite.com

THIS WARRANTY DOES NOT APPLY TO NORMAL WEAR OR TO DAMAGE RESULTING FROM ACCIDENT, MISUSE, ABUSE OR NEGLECT. SELLER MAKES NO EXPRESS WARRANTIES OTHER THAN THE WARRANTY EXPRESSLY SET FORTH HEREIN. EXCEPT TO THE EXTENT PROHIBITED BY APPLICABLE LAW, ALL IMPLIED WARRANTIES, INCLUDING ALL WARRANTIES OF MERCHANTABILITY OR FITNESS, ARE LIMITED IN DURATION TO THE WARRANTY PERIOD SET FORTH ABOVE; AND THIS WARRANTY EXPRESSLY EXCLUDES ALL INCIDENTAL AND CONSEQUENTIAL DAMAGES. (Some states do not allow limitations on how long an implied warranty lasts, and some states do not allow the exclusion or limitation of incidental or consequential damages, so the above limitations or exclusions may not apply to you. This Warranty gives you specific legal rights, and you may have other rights which vary from jurisdiction to jurisdiction).

Tripp Lite; 1111 W. 35th Street; Chicago IL 60609; USA

WARNING: The individual user should take care to determine prior to use whether this device is suitable, adequate or safe for the use intended. Since individual applications are subject to great variation, the manufacturer makes no representation or warranty as to the suitability or fitness of these devices for any specific application. The policy of Tripp Lite is one of continuous improvement. Specifications are subject to change without notice.

17

Image 17
Contents Español Français UPS Location Warnings Important Safety WarningsControl Panel Front PanelBattery Access Panel cover removed Rear Panel Rear PanelMounting Bracket Installation InstallationUPS Input and Output Hardwire Connection UPS LocationWiring Connection Initial Battery ChargingOperation Normal Conditions Output Voltage Selection VIA SoftwareSelf Testing Battery OK DC to DC OK Inverter Test SELF-TESTINGTurning the UPS OFF LCD Display Select ButtonOperation on BYPASS-VOLTAGE OUT of Range Operation Special ConditionsInverter on Warnings Operation Under ShutdownCommunications DRY Contact Interface Remote Emergency Power OFF EPODRY Contact Interface Table OpenBattery Packs are Heavy Do not Remove Battery SleeveCheck Battery Pack Voltage Before Completing Installation Adding or Replacing Internal BatteriesInternal Battery Pack Wiring Diagram Adding or Replacing Internal Batteries Adding or Replacing Internal Batteries Adding or Replacing Internal Batteries Warranty ServiceLimited Warranty Observe Proper PolarityModel SU20K3/3INT SpecificationsModel SU30K3/3INT Manual del Propietario Advertencias sobre la colocación y ubicación del UPS Advertencias de Seguridad ImportantesPanel DE Control Panel FrontalPanel DE Acceso a LA Bateria Tapa Removida Panel Frontal continuaciónPanel Trasero Panel TraseroUbicación DEL UPS InstalaciónInstalacion DE LOS Soportes DE Montaje Conexion a TierraCarga Inicial DE LA Bateria Operación Condiciones NormalesSeleccion DEL Voltaje DE Salida VIA Software Encendiendo EL UPSApagando EL UPS Operación Condiciones Normales continuaciónAUTO-PRUEBA Boton Select Seleccionar DE LA Pantalla LCDOperacion EN DERIVACION-VOLTAJE Fuera DE Rango Operación Condiciones EspecialesAdvertencias DEL Inversor Encendido Operacion Bajo CIERRE/PARADAComunicaciones Operación Condiciones Especiales continuaciónInterfaz DEL Contacto Seco Comunicaciones continuaciónApagado DE Emergencia Remoto EPO Tabla DE LA Interfaz DE Contacto Seco¡LOS Modulos DE Bateria SON Pesados Añadiendo o Remplazando las Baterías Internas¡NO Remueva LA Cubierta Protectora DE LA Bateria Añadiendo o Remplazando las Baterías Internas continuación Diagrama DEL Cableado DEL Modulo DE Baterias InternasAñadiendo o Remplazando las Baterías Internas continuación Terminales ¡PELIGRO Garantía ServicioGarantia Limitada ¡OBSERVE LA Polaridad CorrectaModelo SU20K3/3INT EspecificacionesModelo SU30K3/3INT Especificaciones continuaciónManuel du propriétaire Mises en garde relatives à la localisation de londuleur Importantes consignes de sécuritéPanneau avant Panneau DE CommandePanneau Daccès AUX Batteries carter enlevé Panneau avant suitePanneau Arrière Panneau arrièreMises EN Garde Relatives À LA Localisation DE Londuleur IL Faut Installer Londuleur À Laide DE Brides DE FixationConnexion DE Mise À LA Terre Sélection DU CâblageFonctionnement Conditions normales Installation suitePremière Charge DE LA Batterie Sélection DE LA Tension DE Sortie À Laide DUN LogicielArrêter Londuleur Fonctionnement Conditions normales suiteÉxécution DUN AUTO-TEST Bouton DE Sélection DE Lécran ACLFonctionnement EN DÉRIVATION-TENSION Hors Plag Fonctionnement Conditions spécialesMises EN Garde Inverseur EN Marche Fonctionnement Pendant UN ArrêtFonctionnement Conditions spéciales suite Commuter Londuleur EN Mode NormalFonctionnement DU Commutateur DE Dérivation Manuelle Interface RS-232Arrêt Durgence Emergency Power OFF EPO À Distance Ajout et remplacement des batteries internesCommunications suite Interface Contact SECSchéma DU Câblage Interne DUN Bloc DE Batterie Ajout et remplacement des batteries internes suiteAjout et remplacement des batteries internes suite Bornes Ajout et remplacement des batteries internes suite Observer LA Bonne Polarité GarantieGarantie Limitée À VIE Modèle SU20K3/3INT SpécificationsModèle SU30K3/3INT Spécifications suite