Patton electronic M-ATA manual Distinctive Ring Settings

SmartLink M-ATA Getting Started Guide 6 • System

Distinctive Ring Settings

The SmartLink M-ATA Distinctive Ring Settings window (see figure 33) enables you to specify up to 8 sets of distinctive ring cadences.

Figure 33. Distinctive Ring Setting section of Localization window

The following is a sample ring cadence pattern configuration:

Timeval ::= time in milliseconds

Repeatval ::= # of cycles to repeat

Tonename ::= "RING_0" "RING_1" "RING_2" "RING_3" "RING_4" "RING_5" "RING_6" "RING_7" "RING_8" "RING_9"

Idle ::= "IDLE"

Active ::= "ON" "OFF"

Inactive ::= Idle "(" Timeval ")"

Active ::= Active "(" Timeval ")"

Sequence ::= Active Active "," Sequence

Repetition ::= "[" Sequence "]" Repeatval

Repeat ::= "R"

Cycle ::= Sequence Repetition

Fullsequence ::= Cycle Cycle "," Fullsequence

Cadence ::= Fullsequence Fullsequence "," Repeat Fullsequence

"," Inactive "," Repeat

Ring ::= Cadence

Note The Bellcore standard ring cadence patterns are shown in table 2.

	Table 2. Bellcore standard ring cadence patterns
Name	Value
RING_0	ON(2000), IDLE(4000), R
RING_1	ON(800), OFF(400), ON(800), IDLE(4000), R
RING_2	ON(400),OFF(200)]2,ON(800),IDLE(4000),R
RING_3	ON(300), OFF(200), ON(1000), OFF(200), ON(300), IDLE(4000), R
RING_4	ON(500)
RING_5

Localization 57