Patton electronic M-ATA manual Accessing the voice prompt, Existing voice prompt configuration

SmartLink M-ATA Getting Started Guide E • Voice prompt configuration

Introduction

The M-ATA provides the ability to review and set the network configuration parameters using the handset of an attached analog telephone handset.

By default from the factory, DHCP is enabled and an IP address is not configured.

The M-ATA must be power cycled or reloaded after changing any of the network settings. Menu selection item Network Status will not reflect setting changes until after M-ATA is reloaded or power cycled.

Note Configuration of these settings can result in loss of connectivity to the M-

ATA on the local LAN.

Accessing the voice prompt

Dial **** from the analog handset to reach the main menu.

Existing voice prompt configuration

On hook the analog phone.

Access	Main Menu	Announcement/	Voice Prompt	User input
Code	Selection	Function
****	Main Menu	Plays main	Patton SmartLink Con-	Enter selection code
		menu selections	figuration Main Menu
100#	Network status	Plays DHCP setting, IP	100# Network status	None.
		address, gateway IP
		address and IP network
		mask setting
110#	DHCP setting	Enables or	110# DHCP Settings	1# to enable DHCP
		Disables DHCP		2# to disable DHCP or “#” to
				return to the main menu
120#	IP address	Sets IP address of	120# Set IP Address	Use “*” to instead of “.”, and
	setting	the M-ATA		“#” to end.
				Ex: 172*16*230*227# or
				“#” to return to the main
				menu
130#	Gateway	Sets the gateway router IP	130# Set gateway	Use “*” to instant of “.”, and
	setting	address	router IP address	“#” to end or “#” to return to
				the main menu
140#	Net mask	Set the IP network mask	140# Set IP	Use “*” to instant of “.”, and
	setting		network mask	“#” to end or “#” to return to
				the main menu
150#	Reload	Immediately reloads	None	None
		the SmartLink

Introduction 86