Part Names and Functions
Terminals and Connectors
USB CONNECTOR (Series B)
USB connector is used to service the projector.
5 BNC INPUT JACKS
Connect the component or composite video output signal from video equipment to VIDEO/Y, Pb/Cb, and Pr/Cr jacks or connect the computer output signal (5 BNC Type [Green, Blue, Red, Horiz. Sync, and Vert. Sync.]) to G, B, R, H/V, and V jacks.
D-sub 15-PIN INPUT TERMINAL
Connect computer output (Analog
MONITOR OUT TERMINAL
This terminal can be used to output the incoming analog RGB, component, or composite video out signals from INPUT
DVI INPUT TERMINAL
Connect computer output
HDTV (HDCP Compatible) signal can be also connected. (p.21)
HDMI
Connect the HDMI output signal from video equipment to this terminal. (p.21)
Connect the
SERIAL PORT IN TERMINAL
If you control the projector through
SERIAL PORT OUT TERMINAL
This terminal outputs signal from SERIAL PORT IN. More than two projectors can be controlled through
LAN port
Connecting the Ethernet cable. See the owner's manual of “Network
R/C JACK
When using the wired remote control, connect the wired remote control to this jack with a remote control cable (not supplied).
DHD800 User Manual | 11 | |
|