Christie Digital Systems DHD800 Shutter button, Filter button, Image ADJ. button, Timer button

Basic Operation

SHUTTER button Remote Control

See pages 28 and 60 for details.

SHUTTER button

FILTER button

This button does not work in the default state. When a filter cartridge (supplied) has been installed in the projector, it works as follows:

Press and hold the FILTER button for more than five seconds to replace the filter mechanically. See page 56 for details.

Note:

•The filter cannot be rewound.

•When the filter is replaced, the total accumulated time of the filter use is automatically set to 0.

IMAGE ADJ. button

Press the IMAGE ADJ. button on the remote control to adjust an image level of the screen.

For more detail, see pp.46-48.

IMAGE SEL. button

Press the IMAGE SEL. button on the remote control to select a desired image level of the screen.

For more detail, see pp.39, 43.

P-TIMER button

Press the P-TIMER button on the remote control. The Timer display “00 : 00” appears on the screen and starts to count time (00 : 00–59 : 59).

To stop the P-TIMER, press the P-TIMER button.

To cancel the P-TIMER, press the P-TIMER button again.

	IMAGE ADJ.
	button
	KEYSTONE
	button
P-TIMER	IMAGE SEL.
button
	button
FILTER
button

Note:

•See the previous page for the description of other buttons.

P-Timer display

KEYSTONE button

Press the KEYSTONE button on the remote control. The “Keystone” appears on the screen.

Use the Point 544 buttons to correct keystone distortion. The keystone adjustment can be stored (pp.41, 45).

•The white arrows indicate that there is no correction.

•A red arrow indicates the direction of correction.

•An arrow disappears at the maximum correction.

•If you press the KEYSTONE button on the remote control again while the Keystone dialog box is being displayed, the keystone adjustment will be canceled.

•The adjustable range can be limited depending on the input signal.

• “Keystone” disappears after 10 seconds.

Reduce the upper width with	Reduce the lower width	Reduce the left part with
Point 5 button.	with Point 4 button.	Point  button.

Reduce the right part with Point  button.

DHD800 User Manual	31
020-000244-01 Rev.1 (08-2010)