Barco 9200 owner manual Remote control, Control disc Key on RCU or + and keys cursor, Local keypad

PAUSE : to stop projection for a short time, press 'PAUSE'. The image disappears but full power is retained for imme- diate restarting.

Location and Functions of Control

￿￿

b. Remote control

175

This remote control includes a battery powered infrared (IR) trans-

￿￿

+(/3

- &23+&2/27,117$657(5$67+

mitter that allows the user to control the projector remotely.

67%<3$86(7(;7)5(=(;,7

￿￿

￿

7

8

-

+

This remote control is used for source selection, control,

adaptation and set up. It includes automatic storing of :

Remote Control (RCU)

- picture controls (Brightness, Sharpness...)

9

0

6+$531(66

- settings

Other functions of the remote control are :

- switching between standby and operational mode.

- switching to "pause" (blanked picture, full power for immediate

3

4

%5,*+71(66

restarting)

$'-

- direct access to all connected sources.

- variable adjustment speed : when pushing continuously on the

control disc or the picture keys, the adjustment will be executed

in an accelerated fashion.

?

￿

￿

-

￿

STANDBY

&2175EXIT$67

ENTER

-

5

6

TEXT

-

+

-

+

SHARPN

TINT BRIGHTN

1

2

PHASE

COLOR

Local keypad

Terminology

1Barco Key : not used for this projector.

11

32a

FREEZ : press to freeze the projected image.

2ADJ. : ADJUST key, to enter or exit the adjustment mode.

3Address key (recessed key), to enter the address of the projector (between 0 and 9). Press the sunk address key with a pencil, followed by pressing one digit button between 0 and 9.

4STBY : stand-by button, to start projector when the power switch is switched on and to switch off the projector without switching off the power switch.

5

6Help : on line help information (not yet available)

7Digit buttons : direct input selection.

8	Picture controls : use these buttons to obtain the desired
	picture analog level (see also 'Controlling').

9PHASE : used to remove the instability of the image.

TEXT : when adjusting one of the image, e.g. controls during

10a meeting, the displayed bar scale can be removed by pressing 'TEXT' key first. To re-display the bar scale on the screen, press 'TEXT' key again. 'TEXT' key only active in operational mode.

3-2

12ENTER : to start up the adjustment mode or to confirm an adjustment or selection in the adjustment mode.

13EXIT : to leave the adjustment mode or to scroll upwards when in the adjustment mode.

Control disc Key (on RCU) or '+' and '-' keys (cursor

14keys): to make menu selections when in the adjustment mode.

The control disc can move forward, backward, to the right or to the left.

Comparision between control disc movement and the use of the cursor keys on the local keypad :

RCU			=	local keypad
control	disc	forward	=	'+' key up
control	disc	backward	=	'-' key down
control disc to the right			=	'+' key right
control disc to the left			=	'-' key left

Use the '+' and '-' keys (cursor keys) : to increase or decrease the analog level of the image controls when they are first selected.

RC operating indication : lights up when a button on the

15remote control is pressed. (This is a visual indicator to check the operation of the remote control)

5975967 BARCOGRAPHICS 9200 030798