Connections
Lamp Run Time
When the total run time of the lamp is 970 hours or more, the following message will be displayed for 1 minute. This message will be repeated every 30 minutes. Press EXIT to remove the message before the minute is over.
When the total run time of the lamp is 1000 hours or more, the following message, with the exact run time is displayed on the screen.
Lamp run time is 1000 hours. Operating the lamp longer than 1000 hours may damage the projector. Please replace the lamp.
When OK (ENTER) is pressed to go on, the warning will be repeated every 30 min.
The total lifetime of the lamp for a safe operation is 1000 hours max. (normal power mode). Do not use it longer. Replace always with a same type of lamp. Call a BARCO authorized service technician for lamp replacement.
Warning : Using a lamp for more than 1000 hours is dangerous, the lamp could explode.
Lamp run time 980 hours
WARNING
Lamp run time is 1000 hours Operating the lamp longer
than 1000 hours may damage 
the projector. 
Please replace the lamp
<ENTER> to confirm²
Switching to stand-by.
When the projector is running and you want to go to
Input connections.
The projector has modular input facilities. The input slots can be filled up with the following modules :
Video,
RGBS/RGsB analog input order no. : R9827910
RGB3S/RG3sB input order no. : R9827920
Component Video input order no. : R9827930
The sequence of insertion has no importance, exept when using a RCVDS or VS05. It is even perfectly possible to insert several input modules of one type.
Note : When using RCVDS05 or VS05, the input configu- ration of the projector must be as follows:
Slot 1 : video input module
Slot 2 : RGB analog input module
Slot 3 : Component input module
Input module insertion into the projector :
-Power down the projector and disconnect the power cord from the wall outlet.
-Remove the dummy plate covering the chosen input slot by turning out both screws.
-Slide the input module in the free slot. Insure the module is seated correctly in the guide grooves.
-Press on both handles of the input module until the module plug seats in the connector of the projector.
-Secure the input module by tightening both retaining screws.
-Reconnect the power cord to the wall outlet and switch on the projector.
Switching off
To switch off:
-press first STANDBY key and let cool down until the fans stop blowing ( or at least 15 min).
-switch off the projector with the power switch.
WARNING : When switching to standby, never restart projec- tion (hot restrike) within the first 3 minutes to avoid damage to the lamp.
0 | I |
The new installed module can be selected with the digit buttons on the RCU or the local keypad.
| 5975967 BARCOGRAPHICS 9200 221297 | |
|