Configuring the speakers
2. Use the 
and 
cursor buttons to select “Left.”
(1) Remember the volume level of this noise and then press the 
cursor button. (Note that this can be adjusted to any level between
1.Use the 
and 
cursor buttons to select “4. Level Calibration” on the main menu and then press the ENTER button.
The “Level Calibration” menu appears.
(2)Using the 
and 
cursor buttons, adjust the volume level of the noise from the center speaker so that it is at the same level as that was emitted from the front left speaker. You can jog back and forth between the speakers to help you compare the volume levels.
(3)Press the 
cursor button again. The
(4)Repeat steps (2) and (3) above for the front right and other speakers until all speakers are adjusted to the same volume level.
Notes:
* Menu *****************
1.Hardware Config 2.Speaker Config 3.Speaker Distance
4.Level Calibration
5.Input Setup 6.Preference
ENTERQuit:SETUP
* Menu *****************
1.Speaker Config |
|
4.Level Calibration | |
2.Speaker Distance | |
*********************** | |
3.Level Calibration | |
4.Input Setup | : OdB |
a.Left | |
5.OSD Setup | : OdB |
b.Center | |
6.Preference | : OdB |
c.Right | |
d.Surr Right | : OdB |
e.Surr Back | : OdB |
f.Surr Left | : OdB |
g.Subwoofer | : OdB |
Quit:SETUP
•Speakers that you selected “No” or “None” for in the “Speaker Config” menu will be disabled.
•To accurately set the output levels, it is recommended to use a
handheld sound pressure level (SPL) meter. Set the meter to C- weighting and slow averaging. A Radio Shack® SPL meter or equivalent is recommended. Using the internal channel noise generators, set each channel so that you read a 75 decibel sound pressure level.
Using the remote controller
1. Press the TEST button.
You will hear a pink noise which will be emitted from the front left speaker. At this time, the volume of the pink noise will automatically increase to a predetermined reference level (82).
(1)Remember the volume level of this noise and then press the CH SEL button. The
(2)Using the LEVEL 
/
buttons, adjust the volume level of the noise from the center speaker so that it is at the same level as that was emitted from the front left speaker.
(3)Press the CH SEL button again. The
Use the LEVEL 
/
buttons to adjust the volume of the noise from the front right speaker so that it is the same level as that was emitted from the center speaker.
(4)Use the CH SEL button to select other speakers and adjust the volumes until all speakers are adjusted to the same level.
The pink noise level can be adjusted to anywhere between
2. Press the TEST button to complete the procedure.
Note:
Speakers that you selected “No” or “None” for in the “Speaker Config” menu will be disabled.
2. Use the 
and 
cursor buttons to select “Left.”
You will hear a pink noise from the front left speaker.
(1)Remember the volume level of this noise and then press the 
cursor button. The
(2)Using the 
and 
cursor buttons, adjust the volume level of the noise from the center speaker so that it is at the same level as that was emitted from the front left speaker.
(3)Press the 
cursor button again. The
Use the 
and 
cursor buttons to adjust the volume of the noise from the front right speaker so that it is the same level as that was emitted from the center speaker.
(4)Use the 
cursor button to select other speakers and adjust the volumes until all speakers are adjusted to the same level.
The pink noise level can be adjusted to anywhere between
Press the RETURN button to return to the main menu.
Press the SETUP button on the front panel or on the remote controller button to exit the Setup menu.
35