Onkyo TX-SR601E, TX-SR701E instruction manual Specifications TX-SR701/701E, Amplifier Section

Page 78
Continuous power output (DIN) Maximum power output (EIAJ) Dynamic power output (stereo)
Total harmonic distortion: IM distortion:
Damping factor:
Input sensitivity and impedance
PHONO:
LINE (CD, TAPE, DVD, VIDEO 1-4):
MULTICHANNEL INPUT (FRONT L/C/R, SURROUND L/R):
(SUBWOOFER):
COAXIAL (DIGITAL):
DVD, VIDEO 1, 2, 3, 4:
COMPONENT VIDEO 1, 2:
Output level and impedance Rec out (TAPE, VIDEO 1, 2): Line out:
Pre out:
VIDEO (VIDEO 1, 2,
MONITOR OUT):
COMPONENT VIDEO OUT:
Phono overload: Frequency response:
RIAA deviation: Tone control
Bass:
Treble:
Signal-to-noise ratio (stereo) Phono:
Line:
Muting:
78

Specifications (TX-SR701/701E)

AMPLIFIER SECTION

Continuous average power output (FTC)

All channels:100 W per channel min. RMS at 8 , 2 channels driven from 20 Hz to 20 kHz with no more than 0.08% total harmonic distortion.

125 W min. RMS at 6 , 2 channels driven from 1 kHz with no more than 0.1% total harmonic distortion. 130 W at 6

160 W at 6

2 230 W at 3

2 170 W at 4

2 115 W at 8

0.08% at rated power

0.08% at 1 W output

0.08% at rated power

0.08% at 1 W output

60 at 8

2.5 mV, 47 k

200 mV, 47 k

200 mV, 47 k

36 mV, 47 k

0.5 Vp-p, 75

1 Vp-p, 75

1 Vp-p, 75 (Y)

0.28 Vp-p, 75 (C)

1 Vp-p, 75 (Y)

0.7 Vp-p, 75 (PB, PR)

200 mV, 470

100 mV, 470 (Zone 2)

1 V, 470

1 Vp-p, 75

1 Vp-p, 75 (Y)

0.28 p-p, 75 (C)

1 Vp-p, 75 (Y)

0.7 Vp-p, 75 (PB, PR)

70 mV RMS at 1 kHz, 0.5% T.H.D.

10 Hz to 100 kHz: +1/–3 dB (CD in Direct mode)

20 Hz to 20 kHz: ±0.8 dB

±10 dB at 50 Hz

±10 dB at 20,000 Hz

80 dB (IHF A, 5 mV input, Direct mode)

106 dB (IHF A, 0.5 V input, Direct mode) –50 dB

TUNER SECTION

 

FM

 

Tuning range:

 

USA & Canadian models:

87.50–108.00 MHz (100-kHz steps)

Other area models:

87.50–108.00 MHz (50-kHz steps)

Usable sensitivity

11.2 dBf, 1.0 µV (75 IHF)

Mono:

 

0.9 µV (75 DIN)

Stereo:

17.2 dBf, 2.0 µV (75 IHF)

 

23 µV (75 DIN)

50 dB quieting sensitivity

17.2 dBf, 2.0 µV (75 )

Mono:

Stereo:

37.2 dBf, 20 µV (75 )

Capture ratio:

2.0 dB

Image rejection ratio

 

USA & Canadian models:

40 dB

Other area models:

85 dB

IF rejection ratio:

90 dB

Signal-to-noise ratio

 

Mono:

76 dB

Stereo:

70 dB

Alternate channel attenuation:

55 dB

Selectivity:

50 dB (DIN)

AM suppression ratio:

50 dB

Total harmonic distortion

 

Mono:

0.2%

Stereo:

0.3%

Frequency response:

30 Hz–15 kHz, ±1.0 dB

Stereo separation:

45 dB at 1 kHz

AM

30 dB at 100 Hz–10 kHz

 

Tuning range

 

USA & Canadian models:

530 to 1,710 kHz (10-kHz steps)

European & Australian models:

522 to 1,611 kHz (9-kHz steps)

Worldwide models:

522 to 1,611 kHz (9-kHz steps)

 

530 to 1,710 kHz (10-kHz steps)

Usable sensitivity:

30 µV

Image rejection ratio:

40 dB

IF rejection ratio:

40 dB

Signal-to-noise ratio:

40 dB

Total harmonic distortion:

0.7%

GENERAL

 

Power supply

 

USA & Canadian models:

AC 120 V, 60 Hz

European & Australian models:

AC 230–240 V, 50 Hz

Some Asian models:

AC 220–230 V, 50/60 Hz

Worldwide models:

AC 220–230 and 120 V switchable,

 

50/60 Hz

Power consumption

 

USA & Canadian models:

6.0 A

Other models:

620 W

Dimensions (W H D):

435 175 431.5 mm

 

17-1/8" 6-7/8" 16-15/16"

Weight

 

USA & Canadian models:

26.9 lbs.

Other models:

13.0 kg

REMOTE CONTROLLER

 

Transmitter:

Infrared

Signal range:

Approx. 16 ft., 5 meters

Power supply:

Two “AA” batteries (1.5 V 2)

Specifications and features are subject to change without notice.

Image 78
Contents TX-SR701/701E TX-SR601/601E Important Safety Instructions AvisPrecautions Contents Contents Features TX-SR701/701E Amplifier FeaturesSetting the voltage selector Worldwide models only Supplied accessoriesBefore using this unit Using the remote controllerFront panel facilities TX-SR701ETX-SR601E Front panel facilities Audio Selector button Tuning indicators Muting indicatorListening mode or digital input format indicators Sleep indicatorRemote controller Light button RC-533M only Remote controllerInput Selector buttons VOL buttonLeft white Audio connection cable Right red ConnectionsImproper connection Inserted completely Video connection cable Coaxial cable Optical cableConnections Connecting a turntable Phono TX-SR701/701E only Connecting your audio componentsConnecting a compact disc player CD Signal flowConnecting your video components Connecting a DVD Player with 5.1-Channel Outputflow of the video signals is as follows Connecting a DVD Player with 2-Channel L/R Audio Output Connecting a DVD player DVDConnecting a video cassette recorder Video Video output White Analog audio output R redConnecting a television monitor or projector Monitor OUT Monitor OUTConnecting video camera, etc. Video 4 Input PRE OUT TX-SR701/701E only12V Trigger Zone 2 terminal Cabinet Signal flow From connecting block Mini plug cableTX-SR701/701E/601/601E Connecting Block IR Receiver IR Receiver Connecting block Remote Controller Main roomWhen using the Zone 2 PRE OUT terminals TX-SR701/701E only Connecting the remote zone Zone 2 speakersWhen using the Zone 2 Speakers terminals When using the Zone 2 Line OUT terminalsDirect change function Power on/ready functionPower off function Dimmer functionSpeaker placement Connecting speakersStandard speaker setup for surround sound Important points regarding speaker placementConnecting a subwoofer Connecting speakersUsing the speaker cable labels Connecting the surround back speakers TX-SR701/701E onlyConnecting speakers Connecting the speaker cableStrip away approx /8 inch 15 mm Wire insulation Connecting the power Turning on the powerTurning on the power from the remote controller Connecting the AM antenna cable Connecting antennasConnecting the included antennas Assembling the AM loop antennaConnecting an AM outdoor antenna Connecting antennasConnecting an FM outdoor antenna Directional linkageConfiguring the speakers Displaying the Main MenuSpeaker Configuration Configuring the speakers TX-SR701/701ETX-SR601/601E Speaker Distance menu appears Calibrating the speaker levels Using the remote controller Press the Test button Press the Test button to complete the procedureUse the and cursor buttons to select Left Buttons used for navigating through the menus Displaying the Main Menu and exiting the menuTuned in stereo Auto mode Band Frequency Listening to Radio BroadcastsPress the Tuner input source button Erasing a preset radio station Presetting a radio stationSelecting a preset radio station Listening to Radio BroadcastsWhat is RDS? Listening to RDS broadcasts European models onlyPTY program types in Europe Displaying Radio Text RT Preset RT/PTY/TPListening to RDS broadcasts European models only Performing a TP scanMaster Volume Selecting an Audio ComponentBasic operation Selecting an Audio Component Selecting the type of audio input signalRcvr Mode CH SEL Audio SEL Level Tape Audio SelectorTemporarily changing the speaker output levels To change the display of the input source from Tape to MDChanging the display Using the sleep time remote controller only Listening with headphonesEnjoying DVD multichannel audio playback Switching the display Temporarily turning off the soundListening Modes Listening Modes Tip Selecting a listening mode TX-SR701/701ETX-SR701/701E Listening mode buttons Re-EQRe-EQ function for movies TX-SR701/701E only While playing back Analog/PCM sourcesSelecting a listening mode TX-SR601/601E TX-SR601/601E Listening mode buttonsCine Fltr Press the Cine Fltr button on the remote controller Input Setup Setup Procedure Select the desired input sourceDigital Input Input Setup IntelliVolumeComponent Video Digital Format source For e. PCM fs 96kHz source g. D. F. Mono sourceAnalog/PCM/D. F ch source F. Mono sourceHardware Setup Hardware ConfigTo display the Hardware Config menu Preference PreferenceTo display the Preference menu Audio Adjust Setup Procedure Press the Audio Adjust buttonAudio Adjust Audio Adjust Front Expander Virtual Surr LevelDialog Enhance Using the buttons Adjusting the volume for the remote zoneEnjoying music in the remote zone REC OUT OFF RecordingRecording the input source REC OUT selector Recording a source different from that you are listening toRecording Recording both the audio and videoControlling an Onkyo cassette tape deck Using remote controllerCalling up a preset radio station VOLPress the DVD Mode button Using remote controllerDVD Mode Controlling an Onkyo DVD playerControlling an Onkyo CD player CD Mode DiscPress the CD Mode button On StandbyControlling an Onkyo MD recorder SAT/MD ModePress the SAT/MD Mode button REC RecordLearning a pre-programming code When entering the code of Onkyo DVD playersEntering a pre-programming code DisplayEntering a pre-programming code Pre-programming codesSAT Mode Satellite Tuner Mode Operating your programmed remote controllerDVD Mode DVD Player Mode Cable Mode Cable ModeTV Mode TV Mode Operating your programmed remote controllerVCR Mode VCR Mode VCR Mode VOL TV/VCR MutingProgramming procedure LightMacro 1 Macro Press and release the same Mode button again Erasing the programmed command from one buttonErasing all the commands programmed under a Mode button Press and release the same button againUsing the macro function Programming the macroExecuting the macro Erasing a macro from the Macro 1 or 2 button Using the macro functionErasing all commands and macros that have been programmed Press the Macro 1 or 2 button again Troubleshooting guide Troubleshooting guide Video and AudioIf one of the messages shown below appears Specifications TX-SR701/701E Amplifier SectionSpecifications TX-SR601/601E Amplifier Section Tuner SectionOnkyo U.S.A. Corporation Onkyo Europe Electronics GmbHPage Page Page Page Page Page