Onkyo TX-SR601, TX-SR701 Temporarily changing the speaker output levels, Changing the display

Selecting an Audio Component

Temporarily changing the speaker output levels

To change the individual speaker volumes temporarily, follow the procedure given below. Each channel can be set between –12 and +12 decibels. For subwoofer, values between –15 and +12 decibels can be set. Note that the calibration settings will return to the original settings when the TX-SR701/701E/601/601E is put in standby.

Using the remote controller:

1. Press the RCVR MODE button.

2. Press the CH SEL button and select the desired speaker.

3. Press the LEVEL or button to adjust the volume level.

Notes:

•You cannot select a speaker if the configuration value of the speaker is set to “No” or “None.”

•If the speaker level is set to +1 dB or higher, the maximum level indicated on the display will change if you raise the volume level.

•When you press the TEST button after you set the level, the current level will be used as the value set via the test tone.

To change the display of the input source from TAPE to MD

If you connected an MD recorder to the TAPE jacks of the TX- SR701/701E/601/601E, you can have “MD” appear when the TAPE source button is pressed. By changing the display, when an Onkyo

MD recorder is -connected, the system functions will become enabled.

Changing the display:

Press and hold down the TAPE source button until the display changes from TAPE to MD (approx. 3 seconds).

TAPE

To return the display to its original setting, perform the same

procedure. This setting is necessary to allow system functions for a connected Onkyo cassette tape or MD recorder.

43