Using the macro function
SEND/LEARN indicator
MACRO 1 
MACRO 2
MODE buttons
ENTER
Erasing a macro from the MACRO 1 (or 2) button
1.Press and hold down any one of the seven MODE buttons, press the MACRO 1 (or 2) button, and then release both buttons.
When you press the MODE button, it lights and the SEND/ LEARN indicator lights. When you press the MACRO 1 (or 2) button, the indicator turns off. When you release the buttons, the indicator flashes once.
2.Press the MACRO 1 (or 2) button again.
The SEND/LEARN indicator slowly flashes twice. The macro programmed to the MACRO button is erased.
Notes:
•If the SEND/LEARN indicator quickly flashes three times and turns off, then the remote controller has exited the erasing mode because either you have made a mistake during erasing or a
•If you press a button other than MACRO 1 (or 2) button in Step 2, then you will in effect be overwriting the previous macro with a new macro.
SEND/LEARN indicator
ON 
STANDBY
ENTER
Erasing all commands and macros that have been programmed
This procedure will erase all the commands and macros that you have programmed into the remote controller and return it to its default settings. This operation will not affect the preset settings of the remote controller.
1.Open the battery cover and remove the batteries from the remote controller.
2.While pressing and holding down the ON and STANDBY buttons,
The SEND/LEARN indicator flashes slowly.
3.Press the ENTER button.
The SEND/LEARN indicator lights up for about ten seconds and then turns off.
All programmed commands and macros are erased and the remote controller returns to its factory presets.
Notes:
•Proceed to Step 3 immediately after Step 2; otherwise, the batteries will be consumed quickly.
•If you press any button other than the ENTER button in Step 3, nothing will be erased. In this case, resume from Step 1.
74