Onkyo TX-SR701E, TX-SR601E Switching the display, Temporarily turning off the sound

Selecting an Audio Component

Using the tone control:

To make bass and treble adjustment work for multichannel sources, you must first set the tone control to “On.”

To turn on the tone control:

1.Press the SURROUND button (or SURR button on the remote controller).

TX-SR701/701E/601/601E		Remote controller
	SURROUND

Switching the display

While listening to or watching an input source, you can display the information regarding the type of source and signal being input by pressing the DISPLAY button on the TX-SR701/701E/601/601E or the remote controller.

You can set separate video displays for when the input source is set to AM or FM broadcasts and for when it is set to anything else.

TX-SR701/701E/601601/601E		Remote controller
	DISPLAY

“Tone On” appears on the display and the tone control is turned on.

2.Press the AUDIO ADJUST button and then the and

cursor buttons to select Bass (or Treble).

TX-SR701/701E/601/601E Remote controller

TUNING

PRESET

3.Press the and cursor buttons to set the desired level.

TX-SR701/701E/601/601E	Remote controller
TUNING
PRESET

To turn off the tone control:

Press the DIRECT button.

TX-SR701/701E	TX-SR601/601E	Remote
DIRECT/		controller
PURE AUDIO

DIRECT

“Direct” appears on the display and the tone control is turned off.

Notes:

•(TX-SR701/701E only) When you turn on the tone control, the settings in “Speaker Config” and “Speaker Distance” will be used for multichannel playback.

•(TX-SR701/701E only) When you play back multichannel sources, you can select the Pure Audio mode by pressing the PURE AUDIO button.

To exit the Pure Audio mode, press the DIRECT or SURROUND button.

•If you change the speaker levels in step 4 above, these new levels for multichannel sources will have no effect on the settings at “Level Calibration.”

When an input source other than FM or AM is selected:

Input + volume

Program format or sampling frequency*

Input + Listening mode or Multich

*When the input signal is digital audio

The program format is displayed. For example, the display “Dolby D: 3/2.1” shows that the format is Dolby Digital with 5.1 discrete channels consisting of three front channels (front left, front right, and center), two surround channels (surround left and surround right), and the low frequency effect (LFE) channel.

When the front channel number is 2, they are the front left and front right; when it is 1, it is monaural. When the surround channel number is 1, it is monaural; when it is 0, there is no surround channel. When the LFE number is 0, there is no LFE channel. Also, if there is no program format for the input signal, nothing will be displayed.

When the input signal is linear PCM

The sampling frequency is displayed. For example, the display “PCM fs: 44.1k” shows that the signal is PCM and that the sampling frequency is 44.1 kHz.

When FM or AM is selected as the input source:

FM/AM frequency +

Preset no.

FM/AM + Listening mode

Temporarily turning off the sound

To turn off the sound momentarily, press the	Remote
MUTING button on the remote controller. The	controller
MUTING indicator will flash and the sound from
the speakers or headphones will be switched off
by the receiver’s audio muting circuit. Press the
MUTING button again to turn the sound back on.
Flashes

45