Onkyo TX-SR701E Using the sleep time remote controller only, Listening with headphones

Page 44

Selecting an Audio Component

AUDIO ADJUST

SLEEP

 

STANDBY/ON

POWER

STANDBY

ON OFF

AUDIO

MASTER VOLUME

ADJUST

SETUP RETURN

 

TUNING

PRESET

VOL

AUDIO SEL

 

 

 

 

 

 

 

 

 

 

LISTENING MODE

 

 

 

 

 

 

REC OUT

ZONE 2

OFF

LEVEL

DISPLAY

RT/PTY/TP

STEREO SURROUND

THX

DSP

 

MEMORY

FM MODE

ENTER

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

PHONES

PURE AUDIO

 

 

 

AUDIO ADJUST

DIRECT/

AUDIO

VIDEO 4

INPUT

 

 

PURE AUDIO

SELECTORDVD VIDEO 1

VIDEO 2 VIDEO 3 VIDEO 4TAPE TUNERCDPHONO

 

 

 

 

VCR 1

VCR 2

VIDEO L AUDIO R

 

 

 

 

DIGITALS VIDEO

 

 

 

 

MASTER VOLUME

 

PHONES

 

AUDIO SELECTOR

 

 

Using the sleep time (remote controller only)

The SLEEP button enables you to set the TX-SR701/701E/601/ 601E to turn off automatically after a specified time period. If you press it once, the TX-SR701/701E/601/601E will turn off after 90 minutes. Each time it is pressed thereafter, this remaining time until the TX-SR701/701E/601/601E turns off decreases by 10 minutes (i.e., from 90 to 80 minutes). While the sleep function is enabled, you can press the SLEEP button to see how much time is left. If the SLEEP button is pressed when the time displayed is less than 10 minutes, the sleep function is cancelled.

Remote controller

If you are using the remote zone (Zone 2), it will turn off at the same time as the main zone. If you want to set the sleep function for Zone 2 only, set the sleep function with the main zone turned on and then put the main zone into the standby state.

Listening with headphones

To listen with headphones, plug a pair of headphones with a standard stereo plug into the PHONES jack on the TX-SR701/ 701E/601/601E front panel.

When you connect the headphones, the TX-SR701/701E/601/601E will enter the STEREO mode automatically and no sound will be heard from the speakers. When the headphones are unplugged, the TX-SR701/701E/601/601E returns to its original listening mode. When using the headphones, you can only use the Direct, Stereo, and Pure Audio (TX-SR701/701E only) listening modes. If you have selected multichannel audio, you will only hear the sound output to the front right and left channels.

The headphone volume level can be adjusted at the Setup Menu (see page 56).

PHONES

DIRECT

 

PURE AUD

 

 

Note:

The signal to the remote zone (Zone 2) will not be affected by whether or not headphones are connected.

Enjoying DVD multichannel audio playback

1.Press the DVD input source button.

2.Select “Multich” using the AUDIO SELECTOR button on the front panel (or AUDIO SEL button on the remote controller).

TX-SR701/701E/601/601E

Remote controller

AUDIO

SELECTOR

3.Turn on the connected DVD player and start playing the desired media.

4.If necessary, adjust the output level of each speaker as desired (see page 43).

Adjust the volume at each speaker so that all the volumes sound at the same level at the listening position. For the front right, front left, center, surround right, and surround left speakers, the output levels can be adjusted between –12 and +12 decibels. The subwoofer can be adjusted between –30 and +12 decibels.

5.Adjust the volume with the MASTER VOLUME dial or

the VOL buttons on the remote controller.

44

Image 44
Contents TX-SR701/701E TX-SR601/601E Important Safety Instructions AvisPrecautions Contents Contents Features TX-SR701/701E Amplifier FeaturesSupplied accessories Before using this unitSetting the voltage selector Worldwide models only Using the remote controllerTX-SR601E Front panel facilitiesTX-SR701E Front panel facilities Audio Selector button Muting indicator Listening mode or digital input format indicatorsTuning indicators Sleep indicatorRemote controller Remote controller Input Selector buttonsLight button RC-533M only VOL buttonConnections Improper connection Inserted completelyLeft white Audio connection cable Right red Video connection cable Coaxial cable Optical cableConnections Connecting your audio components Connecting a compact disc player CDConnecting a turntable Phono TX-SR701/701E only Signal flowflow of the video signals is as follows Connecting your video componentsConnecting a DVD Player with 5.1-Channel Output Connecting a DVD Player with 2-Channel L/R Audio Output Connecting a DVD player DVDConnecting a video cassette recorder Video Video output White Analog audio output R redConnecting a television monitor or projector Monitor OUT Monitor OUT12V Trigger Zone 2 terminal Connecting video camera, etc. Video 4 InputPRE OUT TX-SR701/701E only From connecting block Mini plug cable TX-SR701/701E/601/601E Connecting Block IR ReceiverCabinet Signal flow IR Receiver Connecting block Remote Controller Main roomConnecting the remote zone Zone 2 speakers When using the Zone 2 Speakers terminalsWhen using the Zone 2 PRE OUT terminals TX-SR701/701E only When using the Zone 2 Line OUT terminalsPower on/ready function Power off functionDirect change function Dimmer functionConnecting speakers Standard speaker setup for surround soundSpeaker placement Important points regarding speaker placementConnecting speakers Using the speaker cable labelsConnecting a subwoofer Connecting the surround back speakers TX-SR701/701E onlyStrip away approx /8 inch 15 mm Wire insulation Connecting speakersConnecting the speaker cable Turning on the power from the remote controller Connecting the powerTurning on the power Connecting antennas Connecting the included antennasConnecting the AM antenna cable Assembling the AM loop antennaConnecting antennas Connecting an FM outdoor antennaConnecting an AM outdoor antenna Directional linkageSpeaker Configuration Configuring the speakersDisplaying the Main Menu TX-SR601/601E Configuring the speakersTX-SR701/701E Speaker Distance menu appears Calibrating the speaker levels Use the and cursor buttons to select Left Using the remote controller Press the Test buttonPress the Test button to complete the procedure Buttons used for navigating through the menus Displaying the Main Menu and exiting the menuPress the Tuner input source button Tuned in stereo Auto mode Band FrequencyListening to Radio Broadcasts Presetting a radio station Selecting a preset radio stationErasing a preset radio station Listening to Radio BroadcastsPTY program types in Europe What is RDS?Listening to RDS broadcasts European models only Preset RT/PTY/TP Listening to RDS broadcasts European models onlyDisplaying Radio Text RT Performing a TP scanBasic operation Master VolumeSelecting an Audio Component Selecting the type of audio input signal Rcvr Mode CH SEL Audio SEL LevelSelecting an Audio Component Tape Audio SelectorChanging the display Temporarily changing the speaker output levelsTo change the display of the input source from Tape to MD Enjoying DVD multichannel audio playback Using the sleep time remote controller onlyListening with headphones Switching the display Temporarily turning off the soundListening Modes Listening Modes Selecting a listening mode TX-SR701/701E TX-SR701/701E Listening mode buttonsTip Re-EQRe-EQ function for movies TX-SR701/701E only While playing back Analog/PCM sourcesCine Fltr Selecting a listening mode TX-SR601/601ETX-SR601/601E Listening mode buttons Press the Cine Fltr button on the remote controller Digital Input Input SetupSetup Procedure Select the desired input source Component Video Input SetupIntelliVolume For e. PCM fs 96kHz source g. D. F. Mono source Analog/PCM/D. F ch sourceDigital Format source F. Mono sourceTo display the Hardware Config menu Hardware SetupHardware Config To display the Preference menu PreferencePreference Audio Adjust Audio AdjustSetup Procedure Press the Audio Adjust button Audio Adjust Dialog Enhance Front ExpanderVirtual Surr Level Enjoying music in the remote zone Using the buttonsAdjusting the volume for the remote zone Recording Recording the input source REC OUT selectorREC OUT OFF Recording a source different from that you are listening toRecording Recording both the audio and videoUsing remote controller Calling up a preset radio stationControlling an Onkyo cassette tape deck VOLUsing remote controller DVD ModePress the DVD Mode button Controlling an Onkyo DVD playerCD Mode Disc Press the CD Mode buttonControlling an Onkyo CD player On StandbySAT/MD Mode Press the SAT/MD Mode buttonControlling an Onkyo MD recorder REC RecordWhen entering the code of Onkyo DVD players Entering a pre-programming codeLearning a pre-programming code DisplayEntering a pre-programming code Pre-programming codesOperating your programmed remote controller DVD Mode DVD Player ModeSAT Mode Satellite Tuner Mode Cable Mode Cable ModeOperating your programmed remote controller VCR Mode VCR ModeTV Mode TV Mode VCR Mode VOL TV/VCR MutingMacro 1 Macro Programming procedureLight Erasing the programmed command from one button Erasing all the commands programmed under a Mode buttonPress and release the same Mode button again Press and release the same button againExecuting the macro Using the macro functionProgramming the macro Using the macro function Erasing all commands and macros that have been programmedErasing a macro from the Macro 1 or 2 button Press the Macro 1 or 2 button againTroubleshooting guide Troubleshooting guide Video and AudioIf one of the messages shown below appears Specifications TX-SR701/701E Amplifier SectionSpecifications TX-SR601/601E Amplifier Section Tuner SectionOnkyo U.S.A. Corporation Onkyo Europe Electronics GmbHPage Page Page Page Page Page