NAD C 525BEE owner manual Important Safety Instructions

Page 2

IMPORTANT SAFETY INSTRUCTIONS

CAUTION

 

ATTENTION:

RISK OF ELECTRIC

 

RISQUE DE CHOC ELECTRIQUE

SHOCK DO NOT OPEN

 

NE PAS OUVRIR

 

 

 

CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). NO USER SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.

Warning: To reduce the risk of fire or electric shock, do not expose this unit to rain or moisture.

The lightning flash with an arrowhead symbol within an equilateral triangle, is intended to alert the user to the presence of uninsulated “dangerous voltage” within the product’s enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons.

The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the product.

Do not place this unit on an unstable cart, stand or tripod, bracket or table. The unit may fall, causing serious injury to a child or adult and serious damage to the unit. Use only with a cart, stand, tripod, bracket or table recommended by the manufacturer or sold with the unit. Any mounting of the device on a wall or ceiling should follow the manufacturer’s instructions and should use a mounting accessory recommended by the manufacturer.

An appliance and cart combination should be moved with care. Quick stops, excessive force and uneven surfaces may cause the appliance and cart combination to overturn.

Read and follow all the safety and operating instructions before connecting or using this unit. Retain this notice and the owner’s manual for future reference.

All warnings on the unit and in its operating instructions should be adhered to.

Do not use this unit near water; for example, near a bath tub, washbowl, kitchen sink, laundry tub, in a wet basement or near a swimming pool.

The unit should be installed so that its location or position does not interfere with its proper ventilation. For example, it should not be situated on a bed, sofa, rug or similar surface that may block the ventilation openings; or placed in a built-in installation, such as a bookcase or cabinet, that may impede the flow of air through its ventilation openings.

The unit should be situated from heat sources such as radiators, heat registers, stoves or other devices (including amplifiers) that produce heat.

The unit should be connected to a power supply outlet only of the voltage and frequency marked on its rear panel.

The power supply cord should be routed so that it is not likely to be walked on or pinched, especially near the plug, convenience receptacles, or where the cord exits from the unit.

Unplug the unit from the wall outlet before cleaning. Never use benzine, thinner or other solvents for cleaning. Use only a soft damp cloth.

The power supply cord of the unit should be unplugged from the wall outlet when it is to be unused for a long period of time.

Care should be taken so that objects do not fall, and liquids are not spilled into the enclosure through any openings.

This unit should be serviced by qualified service personnel when:

A. The power cord or the plug has been damaged; or

B. Objects have fallen, or liquid has been spilled into the unit; or C. The unit has been exposed to rain or liquids of any kind; or D. The unit does not appear to operate normally or exhibits a

marked change in performance; or

E. The device has been dropped or the enclosure damaged.

DO NOT ATTEMPT SERVICING OF THIS UNIT YOURSELF. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL

Upon completion of any servicing or repairs, request the service shop’s assurance that only Factory Authorized Replacement Parts with the same characteristics as the original parts have been used, and that the routine safety checks have been performed to guarantee that the equipment is in safe operating condition.

REPLACEMENT WITH UNAUTHORIZED PARTS MAY RESULT IN FIRE, ELECTRIC SHOCK OR OTHER HAZARDS.

ATTENTION

POUR ÉVITER LES CHOC ELECTRIQUES, INTRODUIRE LA LAME LA PLUS LARGE DE LA FICHE DANS LA BORNE CORRESPONDANTE DE LA PRISE ET POUSSER JUSQU’AU FOND.

CAUTION

TO PREVENT ELECTRIC SHOCK, MATCH WIDE BLADE OF PLUG TO WIDE SLOT FULLY INSERT.

If an indoor antenna is used (either built into the set or installed separately), never allow any part of the antenna to touch the metal parts of other electrical appliances such as a lamp, TV set etc.

CAUTION

POWER LINES

Any outdoor antenna must be located away from all power lines.

OUTDOOR ANTENNA GROUNDING

If an outside antenna is connected to your tuner or tuner- preamplifier, be sure the antenna system is grounded so as to provide some protection against voltage surges and built-up static charges. Article 810 of the National Electrical Code, ANSI/NFPA No. 70-1984, provides information with respect to proper grounding of the mast and supporting structure, grounding of the lead-in wire to an antenna discharge unit, size of grounding conductors, location of antenna discharge unit, connection to grounding electrodes and requirements for the grounding electrode.

a. Use No. 10 AWG (5.3mm2) copper, No. 8 AWG (8.4mm2) aluminium, No. 17 AWG (1.0mm2) copper-clad steel or bronze wire, or larger, as a ground wire.

b. Secure antenna lead-in and ground wires to house with stand-off insulators spaced from 4-6 feet (1.22 - 1.83 m) apart.

c. Mount antenna discharge unit as close as possible to where lead- in enters house.

d. Use jumper wire not smaller than No.6 AWG (13.3mm2) copper, or the equivalent, when a separate antenna-grounding electrode is used. see NEC Section 810-21 (j).

EXAMPLE OF ANTENNA GROUNDING AS PER NATIONAL ELECTRICAL CODE INSTRUCTIONS CONTAINED IN ARTICLE 810 - RADIO AND TELEVISION EQUIPMENT.

NOTE TO CATV SYSTEM INSTALLER: This reminder is provided to call the CATV system installer’s attention to Article 820-40 of the National Electrical Code that provides guidelines for proper grounding and, in particular, specifies that the ground cable ground shall be connected to the grounding system of the building, as close to the point of cable entry as practical.

NOTES ON ENVIRONMENTAL PROTECTION

At the end of its useful life, this product must not be disposed of with regular household waste but must be returned to a collection point for the recycling of electrical and electronic equipment. The symbol on the product, user's manual and packaging, point this out.

The materials can be reused in accordance with their markings. Through re-use, recycling of raw materials, or other forms of recycling of old products, you are making an important contribution to the protection of our environment.

Your local administrative office can advise you of the responsible waste disposal point.

2

Image 2
Contents 525BEE Important Safety Instructions Rear Panel Connections Front Panel Controls Remote Control Luokan 1 Laserplaite Klass 1 LaserapparatRear Panel Connections Line Output Front Panel Controls Power ON/OFFQuick Start Digital OutputTime OpenPLAY/PAUSE StopPower OFF STAND-BY IndicatorPower on Numeric KeypadCleaning Discs Installing and Replacing BatteriesMaintenance DeleteAbout the Optical Pickup TroubleshootingSymptom Possible Cause Solution Svenska Português Italiano Español Deutsch Français English Sortie Numerique Mise EN Marche RapideBranchements SUR LA Panneau Arriere Sortie Ligne Cordon D’ALIMENTATION SecteurLECTURE/PAUSE PLAY/PAUSE AffichageOuverture Open Temps TimeArrêt Power OFF TelecommandeMarche Power on Repetition RepeatClavier Numerique Partir du mode d’Arrêt StopEn Mode Programmation ProgrammationDisques Pouvant Être LUS PAR CE Lecteur Mise EN Place ET Remplacement DES PilesDisques Audio CD-R & CD-RW EntretienDepannage Probleme Cause Probable Solution Propos DE LA Tete OptiqueAufstellungshinweise Frontplattenelemente Power ON/OFF NetzschalterSchnellstart Rückwandanschlüsse Line Output LINE-AUSGANGOpen Öffnen Display AnzeigefeldTrack Number Titelnummer PLAY/PAUSE ABSPIELEN/PAUSERepeat Wiederholungsmodus Power on Netz EINPower OFF Netz AUS Random Zufälliges AbspielenDelete Löschen Numerisches TastenfeldProgram Programm Im Programm-ModusAbspielbarkeit VON CDS Einsetzen UND Austauschen VON BatterienSTANDARD- UND Beschreibbare AUDIO-CDS CD-R/CD-RW WartungHandtuch abgetrocknet werden ProblemlösungSymptom Mögliche Ursache Abhilfe Wissenswertes Über DEN AbtastlaserSnel Beginnen Aantekening BIJ DE InstallatieBedieningselementen Frontpaneel Power ON/OFF AAN/UIT Aansluitingen Achterpaneel Line OUT-UITGANGENRepeat Herhalen PLAY/PAUSE AFSPELEN/PAUZERENTime Tijd Inschakelen STANDBY-INDICATORAfstandsbediening UitschakelenBatterijen Plaatsen EN Vervangen Terwijl de cd-speler is gestoptDelete Wissen CD-R- EN CD-RW-AUDIOSCHIJFJESSchijfjes Reinigen Problemen OplossenMET CD’S Omgaan Over DE LeeslensPage Conexiones DEL Panel Trasero Line Output Salida DE Línea Inicio RapidoNota Sobre LA Instalacion Digital Output Salida DigitalOpen Abrir VisualizadorCalendar Display Track Listing Lista DE Pistas DE PLAY/PAUSE ESCUCHA/PAUSAControl Remoto Random Escucha AL AzarDiodo LED STAND-BY Teclado NumericoInstalacion Y Cambio DE Pilas Pulse en el control remotoMantenimiento Discos DE Audio CD-R & CD-RWCapacidad DE Escucha DE Discos Manejo DE Discos CompactosSintoma Causa Posible Solucion PowerInvestigacion DE Averias Collegamenti Pannello Posteriore Output DI Linea Comandi Pannello Anteriore Power ON/OFF ACCESO/SPENTOAvviamento Rapido Output DigitaleORE AccesoPLAY/PAUSE ASCOLTO/PAUSA RipetereRandom Casuale Power on AccendiPower OFF Spegni ScansioneDisplay Delete CancellaProgramma Premere il telecomandoRiproducibilitá DEL Disco Installazione E Sostituzione Delle BatterieDischi CD-R E Dischi Audio CD-RW ManutenzioneRicerca Guasti Sintomo Possibili Cause SoluzioneLigações do Painel Traseiro Line Output Saída DE Linha Instalação E Ligação RápidaNota Sobre a Instalação Digital Output Saída DigitalTime Tempo VisorPLAY/PAUSE REPRODUÇÃO/PAUSA Stop ParagemRepeat Repetir Power on Alimentação LigadaPower OFF Alimentação Desligada Random AleatórioVisor Teclado NuméricoProgram Programação Delete ApagarCapacidade DE Reproduçã do Disco Instalação E Substituição DAS PilhasDiscos Áudio CD-R E CD-RW ManutenaçãoSobre O Dispositivo DE Leitura Óptica Resolução DE ProblemasLimpeza DOS CDS Sintoma Causa Possível SoluçãoAnslutningar PÅ Bakpanelen Line Output HUR DU Spelar CD-SKIVOR, EN SnabbgenomgångTänk PÅ Följande VID Inkoppling DigitalutgångSTAND-BY Lysdiod Med TIME-knappen kan du få tidsvisning på två sättScan Bakåt Programmering FjärrkontrollenSiffertangenter Vilka Skivor KAN Spelas BatterierCD-R & CD-RW Audio Skivor Underhåll