Alloy Computer Products GSS-8T16SFP 1 Get/Refresh the Latest QOS Settings, Scheduling Method

Page 38

2.9.1 Get/Refresh the Latest QOS Settings

Click the QOS menu on the web page, the latest QOS settings on the switch will be displayed.

The following parameters can be configured:

Scheduling Method

¾Strict Priority – Sets the switch to transmit packets with Strict Priority algorithm

¾Weighted Round Robin – Set the switch to transmit packets based on a Weighted Round Robin algorithm

Priority/Queue Map

¾To set the Priority and Queue map.

Weight

¾To set the weight for every transmit queue. (Weight range: 1 ~ 15)

¾The weight of a higher queue should not be less than the previous lower queue.

38

Image 38

Contents Version 24x 10/100/1000Mbps ports + 2 paired SFP Ports8x 10/100/1000Mbps ports + 16 SFP Ports Table of Content 11.3 ARL Aging User Management Introduction Main Features Managing The Switch „ IP addressConfiguration Functions for the Switch Configuration Port StatusPort Configuration Page About the Copper/Fiber Media Auto-Detection Port Statistics UnicastPkts Port-Based Vlan Vlan and 802.1Q Vlan can not co-exist at the same timeAdd Port-Based Vlan Groups Page Delete Port-Based Vlan Groups Edit Port-Based Vlan Groups 802.1Q Vlan Enable/Disable Vlan 2 802.1Q Vlan Port Configuration 3 802.1Q Vlan Config Page Page Trunking Trunking Rules Page 2 Get/Refresh the Latest Trunk Settings Enable Trunk Modify Trunk Settings Disable Trunk Port Mirroring 1 Get/Refresh the Latest Mirror Settings Enable Mirror Modify Mirror Settings Disable Mirror QOS Quality of Service 1 Get/Refresh the Latest QOS Settings „ Scheduling MethodEnable QOS Modify QOS Settings Rate and Storm Control Rate ControlPage Storm Control Page System Setup Firmware Update Firmware Update Via Tftp Firmware Update Via BOOTP/TFTP Assign an IP address by Dhcp server Dhcp ClientAssign a fixed IP address ARL Aging User Management Reset System Switch Management Commands In Console Command Line Interface CLIHyper Terminal Setup Options „ Login System„ Get System Information „ Get Current Network Settings„ Help Menu „ Configure Network „ User Management„ Upgrade Firmware Via Tftp or BOOTP/TFTP „ Reboot System„ Reboot System After Write Default „ Logout„ Buffer Memory „ Standards Compliance„ Interfaces „ Packet Forwarding and Filtering Rates„ Weight „ Electromagnetic Emissions Class a „ Power„ Dimensions „ Safety