Alloy Computer Products GSS-24T2SFP, GSS-8T16SFP user manual Firmware Update Via Tftp

Page 47

Firmware Update Via TFTP

To perform the firmware update process, it is necessary to correctly prepare a TFTP server and the firmware file which will be uploaded to the switch by the TFTP server. (Please refer to the TFTP software vendor’s instruction guide for setting up the TFTP server)

When the TFTP server and the firmware file are ready, enter the TFTP server IP address and firmware filename. Click the Apply button to start the firmware update through any RJ-45 port on the switch.

The time for processing the firmware update will be approximately 50 seconds.

NOTE: If the switch can not connect to the TFTP server then click the Cancel button to stop firmware update progress.

47

Image 47

Contents Version 24x 10/100/1000Mbps ports + 2 paired SFP Ports8x 10/100/1000Mbps ports + 16 SFP Ports Table of Content 11.3 ARL Aging User Management Introduction Main Features „ IP address Managing The SwitchConfiguration Functions for the Switch Port Status ConfigurationPort Configuration Page About the Copper/Fiber Media Auto-Detection Port Statistics UnicastPkts Vlan and 802.1Q Vlan can not co-exist at the same time Port-Based VlanAdd Port-Based Vlan Groups Page Delete Port-Based Vlan Groups Edit Port-Based Vlan Groups 802.1Q Vlan Enable/Disable Vlan 2 802.1Q Vlan Port Configuration 3 802.1Q Vlan Config Page Page Trunking Trunking Rules Page 2 Get/Refresh the Latest Trunk Settings Enable Trunk Modify Trunk Settings Disable Trunk Port Mirroring 1 Get/Refresh the Latest Mirror Settings Enable Mirror Modify Mirror Settings Disable Mirror QOS Quality of Service „ Scheduling Method 1 Get/Refresh the Latest QOS SettingsEnable QOS Modify QOS Settings Rate Control Rate and Storm ControlPage Storm Control Page System Setup Firmware Update Firmware Update Via Tftp Firmware Update Via BOOTP/TFTP Assign an IP address by Dhcp server Dhcp ClientAssign a fixed IP address ARL Aging User Management Reset System „ Login System Command Line Interface CLIHyper Terminal Setup Options Switch Management Commands In Console„ Get System Information „ Get Current Network Settings„ Help Menu „ User Management „ Configure Network„ Reboot System „ Upgrade Firmware Via Tftp or BOOTP/TFTP„ Logout „ Reboot System After Write Default„ Packet Forwarding and Filtering Rates „ Standards Compliance„ Interfaces „ Buffer Memory„ Safety „ Power„ Dimensions „ Weight „ Electromagnetic Emissions Class a