Alloy Computer Products GSS-24T2SFP Command Line Interface CLI, Hyper Terminal Setup Options

Page 53

2.14 Command Line Interface (CLI)

In addition to the web management interface, the GSS-24T2SFP web smart switch also provides a serial interface (RS-232) as a console port on the rear panel to manage the switch. A Windows Hyper Terminal session is recommended for use. This section will explain how to setup and use Hyper Terminal to manage this switch.

2.14.1 Hyper Terminal Setup Options

Baud Rate: 19200 bps

Data Bits: 8

Parity: None

Stop bits: 1

Flow control: None

2.14.2 Switch Management Commands In Console

Login System

After the system has started, the following prompt will displayed on the Hyper Terminal session. The administrator needs a valid username and password to login this system. The username and password in CLI are the same as the ones using for login access through the web page.

After entering the username, the following prompt will be displayed. The Administrator should enter the correct password.

53

Image 53

Contents Version 24x 10/100/1000Mbps ports + 2 paired SFP Ports8x 10/100/1000Mbps ports + 16 SFP Ports Table of Content 11.3 ARL Aging User Management Introduction Main Features „ IP address Managing The SwitchConfiguration Functions for the Switch Port Status ConfigurationPort Configuration Page About the Copper/Fiber Media Auto-Detection Port Statistics UnicastPkts Vlan and 802.1Q Vlan can not co-exist at the same time Port-Based VlanAdd Port-Based Vlan Groups Page Delete Port-Based Vlan Groups Edit Port-Based Vlan Groups 802.1Q Vlan Enable/Disable Vlan 2 802.1Q Vlan Port Configuration 3 802.1Q Vlan Config Page Page Trunking Trunking Rules Page 2 Get/Refresh the Latest Trunk Settings Enable Trunk Modify Trunk Settings Disable Trunk Port Mirroring 1 Get/Refresh the Latest Mirror Settings Enable Mirror Modify Mirror Settings Disable Mirror QOS Quality of Service „ Scheduling Method 1 Get/Refresh the Latest QOS SettingsEnable QOS Modify QOS Settings Rate Control Rate and Storm ControlPage Storm Control Page System Setup Firmware Update Firmware Update Via Tftp Firmware Update Via BOOTP/TFTP Assign an IP address by Dhcp server Dhcp ClientAssign a fixed IP address ARL Aging User Management Reset System Hyper Terminal Setup Options Command Line Interface CLISwitch Management Commands In Console „ Login System„ Get System Information „ Get Current Network Settings„ Help Menu „ User Management „ Configure Network„ Reboot System „ Upgrade Firmware Via Tftp or BOOTP/TFTP„ Logout „ Reboot System After Write Default„ Interfaces „ Standards Compliance„ Buffer Memory „ Packet Forwarding and Filtering Rates„ Dimensions „ Power„ Weight „ Electromagnetic Emissions Class a „ Safety