Alloy Computer Products GSS-24T2SFP, GSS-8T16SFP 1 Get/Refresh the Latest Mirror Settings

Page 33

2.8.1 Get/Refresh the Latest Mirror Settings

Click the Mirror menu on the web page, the latest mirror settings on the switch will be displayed.

The following parameters can be set:

„Mirroring Options – There are four options for each port:

¾Disable Mirror – to disable mirror function.

¾Mirror All Frames – to set the corresponding port configuration to monitor bi-directional traffic.

¾Mirror Incoming Frames – to set the corresponding port configuration to monitor ingress traffic only (receiving, Rx).

¾Mirror Outgoing Frames – to set the corresponding port configuration to monitor egress traffic only (transmitting, Tx).

„Monitored Port – The port which is to be monitored. (more than one can be selected)

„Capture Port – All traffic mirrored from monitored port is sent to this port.

33

Page 32 Page 34
Image 33
Page 32 Page 34
Contents 24x 10/100/1000Mbps ports + 2 paired SFP Ports 8x 10/100/1000Mbps ports + 16 SFP PortsVersion Table of Content 11.3 ARL Aging User Management Introduction Main Features „ IP address Managing The SwitchConfiguration Functions for the Switch Port Status ConfigurationPort Configuration Page About the Copper/Fiber Media Auto-Detection Port Statistics UnicastPkts Vlan and 802.1Q Vlan can not co-exist at the same time Port-Based VlanAdd Port-Based Vlan Groups Page Delete Port-Based Vlan Groups Edit Port-Based Vlan Groups 802.1Q Vlan Enable/Disable Vlan 2 802.1Q Vlan Port Configuration 3 802.1Q Vlan Config Page Page Trunking Trunking Rules Page 2 Get/Refresh the Latest Trunk Settings Enable Trunk Modify Trunk Settings Disable Trunk Port Mirroring 1 Get/Refresh the Latest Mirror Settings Enable Mirror Modify Mirror Settings Disable Mirror QOS Quality of Service „ Scheduling Method 1 Get/Refresh the Latest QOS SettingsEnable QOS Modify QOS Settings Rate Control Rate and Storm ControlPage Storm Control Page System Setup Firmware Update Firmware Update Via Tftp Firmware Update Via BOOTP/TFTP Dhcp Client Assign a fixed IP addressAssign an IP address by Dhcp server ARL Aging User Management Reset System Hyper Terminal Setup Options Command Line Interface CLISwitch Management Commands In Console „ Login System„ Get Current Network Settings „ Help Menu„ Get System Information „ User Management „ Configure Network„ Reboot System „ Upgrade Firmware Via Tftp or BOOTP/TFTP„ Logout „ Reboot System After Write Default„ Interfaces „ Standards Compliance„ Buffer Memory „ Packet Forwarding and Filtering Rates„ Dimensions „ Power„ Weight „ Electromagnetic Emissions Class a „ Safety
Top Page Image Contents