Alloy Computer Products GSS-8T16SFP, GSS-24T2SFP user manual Reset System

Page 52

2.13 Reset System

The switch can be rebooted or factory defaulted via the following methods.

Click Reboot System menu to reboot the switch.

Click Reset System menu to reset the switch to its factory default settings.

¾Reboot System –Reboot the system. All configuration settings will be retained. If you want to keep all your configurations then select this option.

¾Reset System – Reset all configurations (including the username, password and IP address; only the MAC address will not be changed) to default settings before rebooting the system. Means that any customized configurations will be lost and can not be recovered.

The GSS-24T2SFP web smart switch also provides an alternative to Reset System by using the Reset button on the rear panel:

¾While the system is running (the DIAG LED indicator is ON), pressing and holding the Reset button (over 5 seconds) until the DIAG LED indicator begins flashing, at any time will activate the Write Default procedure.

After this procedure is completed, the switch will be rebooted and initialized using the default settings automatically.

The GSS-24T2SFP switch takes approximatly10 seconds to reboot. You need to login the system again to enter the web management configuration.

52

Image 52

Contents 8x 10/100/1000Mbps ports + 16 SFP Ports 24x 10/100/1000Mbps ports + 2 paired SFP PortsVersion Table of Content 11.3 ARL Aging User Management Introduction Main Features Managing The Switch „ IP addressConfiguration Functions for the Switch Configuration Port StatusPort Configuration Page About the Copper/Fiber Media Auto-Detection Port Statistics UnicastPkts Port-Based Vlan Vlan and 802.1Q Vlan can not co-exist at the same timeAdd Port-Based Vlan Groups Page Delete Port-Based Vlan Groups Edit Port-Based Vlan Groups 802.1Q Vlan Enable/Disable Vlan 2 802.1Q Vlan Port Configuration 3 802.1Q Vlan Config Page Page Trunking Trunking Rules Page 2 Get/Refresh the Latest Trunk Settings Enable Trunk Modify Trunk Settings Disable Trunk Port Mirroring 1 Get/Refresh the Latest Mirror Settings Enable Mirror Modify Mirror Settings Disable Mirror QOS Quality of Service 1 Get/Refresh the Latest QOS Settings „ Scheduling MethodEnable QOS Modify QOS Settings Rate and Storm Control Rate ControlPage Storm Control Page System Setup Firmware Update Firmware Update Via Tftp Firmware Update Via BOOTP/TFTP Assign a fixed IP address Dhcp ClientAssign an IP address by Dhcp server ARL Aging User Management Reset System Command Line Interface CLI Hyper Terminal Setup OptionsSwitch Management Commands In Console „ Login System„ Help Menu „ Get Current Network Settings„ Get System Information „ Configure Network „ User Management„ Upgrade Firmware Via Tftp or BOOTP/TFTP „ Reboot System„ Reboot System After Write Default „ Logout„ Standards Compliance „ Interfaces„ Buffer Memory „ Packet Forwarding and Filtering Rates„ Power „ Dimensions„ Weight „ Electromagnetic Emissions Class a „ Safety