Allied Telesis AT-DC2552XS, AT-PWR06, AT-FAN06 manual Installing the Switch and Modules

Chapter 3: Installing the Switch and Modules

This procedure requires the following items:

Eight bracket screws (included with the switch)

Two equipment rack brackets (included with the switch)

Cross-head screwdriver (not provided)

Four standard equipment rack screws (not provided)

Perform this procedure to install the switch in a 19-inch equipment rack:

Note

If you have installed the rubber feet, remove the rubber feet by prying them off the bottom of the chassis with a flat-bladed tool.

1.Secure the two rack mount brackets to the sides of the switch using the eight bracket screws provided. Figure 16 shows an example of mounting the rack mount bracket on the front of the chassis and with the bracket flush to the front panel. See Figure 15 for other possible bracket mounting positions on the chassis.

Figure 16. Attaching the Brackets to Switch

Caution

The chassis may be heavy and awkward to lift. Allied Telesis recommends that you get assistance when mounting the chassis in an equipment rack.  E28

46