Chapter 3: Installing the Switch and Modules
Installing and Replacing AT-FAN06 Fan Module
Installing Fan Module
The following procedures are included in this section:
“Installing and Replacing
“Replacing Fan Module” on page 54
The
Perform the following procedure to install an
1.Loosen the captive screws on the fan blank cover panel on Fan 1 (left) slot. See Figure 21.
Figure 21. Loosen Screws on Fan Blank Cover
2.Remove the blank cover and store in a safe place.
3.Gently push the fan module into the slot with the handles on the fan module until the module front panel is flush with the chassis front panel. See Figure 22.
Figure 22. Insert AT-FAN06 Module Into Chassis
52