Installing a SFP+
Direct Attach
Cables
Stack Installation Guide for AT-2552XS L2 Data Center Switch
7.Refer to Table 9 on page 56 for the recommended fiber optic cable. Insert the cable to the port on the transceiver, as shown in Figure 28, until it snaps in place.
Figure 28. Attaching a Fiber Optic Cable to an SFP+ Transceiver
8.Repeat steps 6 and 7 for the cable installation into the remaining SFP+ transceivers that are installed.
The AT-SP10TW1, AT-SP10TW3 and AT-SP10TW7 10G direct attach cables come in 1m, 3m, and 7m cable lengths respectively. These SFP+ cable modules are ordered and supplied separately from the AT-DC2552XS.
Perform the following procedure to install a SFP+ direct attach cables:
1.Remove the dust plug from a SFP+ slot on the switch. Refer to Figure 29.
Figure 29. Removing the Dust Plug from a SFP+ Slot
59