Allied Telesis AT-IFS802SP manual State Activity

Page 51

AT-IFS802SP-80 User Manual

47

6.15.3 State Activity

Having set up the LACP aggregator on the tab of Aggregator Setting, you can configure the state activity for the members of the LACP trunk group.You can tick or cancel the checkbox beside the state label. When you remove the tick mark of the port and click Apply , the port state activity will change to Passive.

•Active:The port automatically sends LACP protocol packets.

•Passive:The port does not automatically send LACP protocol packets, and responds only if it receives LACP protocol packets from the opposite device.

[note]

A link having two passive LACP nodes will not perform dynamic LACP trunk because both ports are waiting for an LACP protocol packet from the opposite device.

State Activity of Switch 1

State Activity of Switch 2

Image 51

Contents AT-IFS802SP Installation and User’s Guide Page Electrical Safety and Emissions Standards Page Preface Preface Content 21.3 Appendix B-Command SetsPage Introduction Hardware FeaturesCSMA/CD Snmp MIB Software FeaturesPackage Contents Physical Dimension Hardware DescriptionFront Panel Top View LED LED IndicatorsInstallation Steps Hardware InstallationDIN-Rail Mounting Wall Mount Plate Mounting Wiring the Power Inputs Wiring the Fault Alarm Contact Gigabit Copper/SFP SFP combo port CablingPage Ring Application Network ApplicationCoupling Ring Application Dual Homing Application Connecting to the Console Port Console ManagementPin Assignment CLI Management Login in the Console InterfaceExec Commands LevelPreparing for Web Management System LoginWeb-Based Management About Web-based ManagementSystem Information IP Configuration Dhcp Server System configurationPort and IP Bindings Client EntriesUpdate Firmware Restore ConfigurationTftp Backup Configuration Syslog ConfigurationSystem Event Log System Event Log-SMTP Configuration System Event Log Event Configuration Event Configuration interface Sntp Configuration Fault Relay AlarmPage Page IP Security Port Statistics User AuthenticationPort Control Port Trunk Aggregator settingState Activity tab Aggregator Information Lacp disabledLacp enabled Page State Activity Port Mirroring Rate Limiting Port-based Vlan Vlan configurationVlan Port Based interface 18.2 802.1Q Vlan 802.1Q Configuration Page Rapid Spanning Tree Rstp System ConfigurationPort Configuration Snmp Configuration Trap Configuration SNMPV3 Configuration QoS Policy and Priority Type QoS ConfigurationPort-based Priority Igmp Configuration COS ConfigurationTOS Configuration Ring Page Security-802.1X/Radius Configuration Lldp Configuration802.1x System Configuration interface Misc Configuration MAC Address TableStatic MAC Address MAC Filtering MAC Address Table-Multicast Filtering All MAC AddressesMulticast Filtering interface Factory Default Save ConfigurationSystem Reboot Troubles shooting RJ-45 Pin Assignments Appendix A-RJ-45 Pin Assignment10/100/1000Base-TX Pin outs 10/100/1000Base-TX Cable Schematic System Commands Set Appendix B-Command SetsSubnet mask PasswordLow IP High IP101001000auto Port Commands SetPortid Duplex full halfDisable State EnableTrunk Commands Set Vlan Commands Set Vlan 8021q trunk Time seconds Spanning Tree Commands Set~61440 SecondsPort Priority AutoTrueFalseTrueFalse Commands Set Show igmp Igmp enableIgmp-query auto Igmp-query forceShow mac-address Mac-address-tableStatic hwaddr Filter hwaddrCommunity-string Authentication Password PrivacyV1v2cv3v1v2cv3 Strings CommunityView Name ExcludedIncludedHost-address RXTXBoth Port ID WordsSec Accept authorize Disable rejectFlashrestorecfg BackupFlashbackupcfg RestoreSystemLog, Smtp and Event Commands Set Change No event authenticationFailure No event ring-topologyTimezone Sntp Commands SetStart time End time MinuteRing Commands Set Control PortDual Homing Port