Perle Systems 5500208-41 manual Set Multihost Line, Set Line Initiate-Connection

Line Service Commands

	protocol
	Specify the protocol that is used between the Modbus Master and Modbus Slave(s),
	either TCP or UDP.
	range-mode
	If you specify Host, the IP address is used for the first UID specified in the range. The
	last octect in the IPv4 address is then incremented for subsequent UID’s in that range.
	The Host option is not applicable for IPv6 addresses. If you specify Gateway, the
	Modbus Master Gateway will use the same IP address when connecting to all the
	remote Modbus slaves in the specified UID range.
	slave-ip
	The IP address of the TCP/Ethernet Modbus Slave.
	uid-range
	When Range Mode is Host and you have sequential Modbus Slave IP addresses (for
	example, 10.10.10.1, 10.10.10.2, 10.10.10.3, etc.), you can specify a UID range and the
	IOLAN will automatically increment the last digit of the configured IP address.
	Therefore, you can specify a UID range of 1-100, and the IOLAN will route Master
	Modbus messages to all Modbus Slaves with IP addresses of 10.10.10.1 - 10.10.10.100.
Set Multihost Line
Description	Configures multiple hosts or a primary/backup host schema for Silent Raw, Reverse
	Raw, or Client-Initiated TruePort service types (multihost must be enabled by the line
	service type for this to take effect, see Set Line Service on page 45 for the command to
User Level	enable multihost).
	Admin
Syntax	set multihost line <number> entry <number> host <host> <TCP_port>
	set multihost line <number> entry <number> delete
Options	entry
	You can specify up to 100 hosts in the multihost table.
	host <host>
	Specify the preconfigured host that will be in the multihost list.
	<TCP_port>
	Specify the TCP port that the IOLAN will use to communicate to the Host.
	delete
	Deletes the specified entry from the multihost table.
Set Line Initiate-Connection
Description	Determines how the connection is initiated for Direct Telnet.
User Level	Admin
Syntax	set line <number>* initiate-connection
	any-charspecific-char <hex>
Options	any-char

Initiates a connection to the specified host when any data is received by the serial port. specific-char <hex>

Initiates a connection to the specified host only when the specified character is received by the serial port.

54 IOLAN DS1/TS2 CLI Reference Guide, Version 4.1