Omega OME-A822PG manual Setup, Base address selection screen

Page 49

5.2.1Setup

The Setup menu allows the user to setup the board configuration. There are six functions in this muen, Card type, Base Addresss, DMA no, IRQ no, Save option, eXit.

Card type : <Up/Down> key to select A-822PGL/PGH, <Enter> key to select

Base Address : <Up/Down> key to select base address, <Enter> key to select

DMA no : <Up/Down> key to select DMA no, <Enter> key to select

IRQ no : <Left/Right> key to select IRQ no, <Enter> key to select

Save option : <Left/Right> key to select yes/no, <Enter> key to select

eXit : <Left/Right> key to select yes/no, <Enter> key to select

Base address selection screen.

OME-A-822PGL/PGH Hardware Manual ---- 47

Image 49

Contents User’sGuide Mexico CanadaBenelux Czech RepublicOME-A-822PGH/PGL Introduction Tables of ContentsConnector General Description FeaturesPower Consumption SpecificationsAnalog Inputs 3 A/D ConverterDigital I/O DA ConverterInterrupt Channel Direct Memory Access Channel DMA Programmable Timer/CounterProduct Check List ApplicationsBoard Layout Hardware ConfigurationDefault base address is I/O Base Address Setting1 JP1 D/A Internal Reference Voltage Selection Jumper Settings3 JP3 Single-ended/Differential Selection 2 JP2 D/A Int/Ext Ref Voltage Selection5 JP5 Interrupt Level Selection 4 JP4 A/D Trigger Source Selection6 JP6 User Timer/Counter Clock Input Selection DRQ JP7 Dack JP8 DMA 7 JP7 DMA Dack Selection JP8 DMA DRQ SelectionAddress Read Write I/O Register Address2 A/D Input Buffer Register 1 8254 CounterConversion is completed, the Ready bit will clear to zero 3 D/A Output Latch Register Clear Interrupt Request 4 D/I Input Buffer RegisterGAIN3 GAIN2 GAIN1 GAIN0 6 A/D Gain Control Register7 A/D Multiplex Control Register OME-A-822PGH Gain Control Code Table8 A/D Mode Control Register 9 A/D Software Trigger Control Register 10 D/O Output Latch Register CN2 Digital I/OCounter 8254 Timer/CounterA/D Conversion Polling, interrupt and DMA 1 A/D conversion flow3 A/D Transfer Modes 2 A/D Conversion Trigger ModesDelay the settling time refer to Sec .4.6 and Sec Using software trigger and polling transferRefer to Sec D/A Conversion Analog Input Signal Connection OME-A-822PGL/PGH Hardware Manual OME-A-822PGL/PGH Hardware Manual Use a single connection to frame ground not A.GND or D.GND Signal ShieldingUsing OME-DB-8225 CJC Output CN1 Digital Input Pin Assignment CN1/CN2/CN3 Pin AssignmentCN2 Digital Output Pin Assignment SINGLE-ENDED Signal Mode Differential Signals OME-DB-8225 Daughter BoardOME-DB-37 OME-DB-16PDescription of Variable Resistors CalibrationD/A Calibration A/D Calibration Introduction Diagnostic UtilityOME-A-822PGL/PGH Hardware Manual Running The Diagnostic Utility Base address selection screen SetupDMA no and IRQ no selection screen Calibration Function Test Test Test Screen Digital I/O Test Screen Multiplexer Test Screen Use IRQ Test Screen Use DMA Test Screen DA Gain Test Screen Timer 0 Test Screen Special Test Help WARRANTY/DISCLAIMER Temperature