Trap Receivers
Receiver No. | Select the Trap Receiver number (1..4), and click the Get Data button |
| to update the display for the selected item. |
|
|
IP Address | Enter the IP Address of the Trap Receiver, which will be sent the |
| Trap message. |
|
|
Community | This is a text field. Enter the name of the community. |
|
|
Enable | Check to enable; select the severity level. |
| Note: Currently, all traps are level 1. |
|
|
TCP/IP
| Figure 15: TCP/IP Screen |
|
|
IP Address | IP Address assigned to this device. If using dynamic IP Addresses |
| (DHCP, BOOTP, rarp), this should be left at 0.0.0.0. |
|
|
Subnet Mask | If the Router (Gateway) Address is 0.0.0.0, the Subnet Mask should |
(Network Mask) | also be left at 0.0.0.0. If you have a router, enter the Subnet mask for |
| the segment to which the LevelOne Printer Server is attached. |
|
|
Gateway | If your network segment has a router or gateways, enter its IP |
Address | Address here. Otherwise, leave the address as 0.0.0.0. |
|
|
Connection |
|
|
|
Delay before | Sets how long the LevelOne Printer Server should wait before |
reconnection | retrying a TCP/IP connection which is lost. Allowable values are |
attempts | from 0 to 255 seconds, with 2 as the default. |
|
|
Number of | Set how many attempts at reconnection will be made. After that, the |
reconnection | TCP/IP session will be terminated. |
attempts | Allowable values are from 0 to 255, with 254 as the default. |
|
|
Page 38