AT&T feature module 2 system manual When the copy is complete, the red light stops flashing

With a BIS-34D Console

1 Touch Adm Tel.

The green light next to Adm Tel becomes steady. The other lights go off.

2 Touch the Auto Intercom button for the voice terminal to which you want

to assign lines.

A steady green light comes on next to the voice terminal’s Auto Intercomn button. The system gives a 2-beep signal for you to begin.

NOTE: If the voice terminal is being used, the green light next Adm Tel flashes rapidly and you don’t hear the 2-beep signal. You must either wait until the green light becomes steady or try again later. If you try to assign lines to a busy voice terminal, you’ll hear a single beep and won’t be able to proceed.

3 Touch the appropriate line buttons to add or remove lines from this voice

terminal. The green light next to each line button tells you the current status of the line. Each successive touch of a line button gives you one of the following codes:

Green light on = line is assigned to voice terminal

Green light off = line is not assigned to voice terminal

The order in which you touch the line buttons determines the order in which lines appear on the voice terminal.

If you want to give another voice terminal the same line assignments as one you have already set up, use the following procedure. However, be aware that when you copy line assignments, you also copy call restrictions and allowed-list permissions. To copy line assignments to another voice terminal:

a Touch the Auto Intercom button of the new voice terminal.

b Touch Recall.

The red light next to Adm Tel flashes.

c Touch the Auto Intercom button of the original voice terminal.

When the copy is complete, the red light stops flashing.

d Repeat steps b and c for each voice terminal for which you want to

	copy line assignments.
	To make line assignments to a different voice terminal, repeat steps 2
	and 3.
	4 Touch Adm Tel and go on to another procedure, or leave administration
	mode.
HOW TO USE	The guides for users and attendants explain how to place calls in behind-
	switch systems. Be sure that everyone in your business knows that this is a
	behind-switch system and understands how to use the line buttons.

MERLIN II System Features 2-89