AT&T feature module 2 system manual Program Mode, Blank, Not Programmable

Program Mode

When you begin programming, the display tells you that you are in the program mode and the intercom number of the voice terminal you are programming.

As you dial characters for the programming procedures, the characters appear on your screen.

* 9 0 9 2 0 1 5 5 5 6 7 8 9

If you touch a button that has already been programmed, the display identifies the name of the feature on that button. The screen below shows that you have programmed the Last Number Redial feature on this voice terminal button.

If the button has not been programmed, this message appears on the display screen:

Blank

If you touch a fixed feature, or nonprogrammable button, such as Conference, the following message appears on the display screen: (Note that you can use nonprogrammable buttons, such as Hold or Recall, to enter a special character, such as a pause or a stop, into a dialing sequence. Also, pressing Hold will cause “ERROR” to be displayed.)

Not Programmable

MERLIN II System Features 2-57