AT&T feature module 2 Touch the Auto Intercom button for the voice terminal, Following codes

ADMINISTRATION	Before you begin, be sure that the system is set in a behind-switch
	configuration. See “Behind-Switch Operation. ” Have the Station
	Configuration Forms handy.
	Be sure to label the voice terminal buttons with the telephone numbers of the
	lines you assign. To assign lines to buttons, enter administration mode and
	follow the appropriate procedure below.
	With a MERLIN II System Display Console
	1 From the administration menu, touch these buttons: [Stations], [Line/Pool] .
	2 Touch the Auto Intercom button for the voice terminal.
	3 Touch [Enter] .
	A steady green light comes on next to the voice terminal’s Auto intercom button. The
	system gives a 2-beep signal for you to begin.
	NOTE: If the voice terminal is being used, the message, “station busy -
	please wait, ” shows on your display. You must either wait until the
	station becomes available or try again later.
	4 Touch the appropriate line buttons to add or remove lines from this voice
	terminal. The green light next to each line button tells you the current
	status of the line. Each successive touch of a line button gives you one of
	the following codes:
	Green light on	= line is assigned to voice terminal
	Green light off	= line is not assigned to voice terminal

The lines are assigned in the order in which you touch the line buttons.

If you want to give another voice terminal the same line assignments as one you have already set up, use the following shortcut:

NOTE: Be aware that when you copy line assignments, you also copy call restrictions and allowed-list permissions. Be sure you want the two voice terminals to be identical in these respects before using this Copy procedure.

aTouch [Copy] .

bIn response to the prompt, touch the Auto Intercom button of the station you are copying from.

cTouch [Enter] .

dIn response to the prompt, touch the Auto Intercom button of the station you are copying to.

eTouch [Enter] .

—.

You hear a 2-beep signal to let you know that the copy procedure is complete.

fRepeat steps b through e for each voice terminal for which you want to copy line assignments.

gTouch [Exit], to return to the Stations screen.

To make line assignments to a different voice terminal, touch [Line/Pool] and repeat steps 2 through 5.

5 Touch Conference to return to the administration menu.

2-88MERLIN II System Features