AT&T feature module 2 system manual Setting the System Time and Date with a BIS-34D Console

Although the system is factory-set to record incoming as well as

outgoing calls, the administrator can set the system not to record them.

The system is factory-set to record only outgoing calls that last at least 1 minute. However, the system administrator can change that setting

for a longer (up to 99 minutes) or shorter (as little as 10 seconds) minimum duration.

If the administrator has assigned a System Speed Dial code to an

outside number, he or she can specify which of these numbers should be printed on call reports and which should remain private. When the administrator designates a System Speed Dial code as private or

		“marked,” the 3-digit code (#60 through #99) is printed on the call
		report in place of the telephone number. (See “System Speed Dial.”)
	● A call report includes only the first 15 digits of a telephone number or
		account code. If the number contains more than 15 digits, a “?” is printed
		on the sixteenth position.
ADMINISTRATION	For both Call Report and Night Service, the administrator must set the initial
	time and the date, and reset the time as needed, such as when daylight
	saving times goes into effect. For Call Report, the administrator has the
	option of setting the type of calls and the minimum duration of a call that will
	be reported.
	Enter administration mode and follow the appropriate procedures below to
	set the time and date, if necessary, and to specify Call Report options.
	Setting the System Time and Date with a MERLIN II System Display
	Console
	1	From	the administration menu, touch [System], [Mode], [Time] .
	2 Dial two digits for the hour (00 through 23) and two digits for the minute
		(00 through 59).
	3	Touch [Enter] .
	4	Touch		[Date] .
	5 Dial two digits for the month (01 through 12), two digits for the day (00
		through 31), and two digits for the year (00 through 99).
	6	Touch		[Enter] .
	7 Touch Conference to return to the administration menu.
	Setting the System Time and Date with a BIS-34D Console
	1 Touch			Message.
	2 To set the current time, dial #300.
	3 Dial two digits for the hour (00 through 23).

4 Dial two digits for the minute (00 through 59).

For example, if the time is 9:16 a.m., dial #300 09 16; if the time is 1:16 p.m., dial #300 1416.

Check the time shown on the display. If it isn’t correct, enter the information again.

MERLIN II System Features 2-31