AT&T feature module 2 system manual Touch Conference twice

Administration Procedure		Do This
Call restrictions and allowed lists	1 Touch	Message.
continued):	2 Dial	#4.
To assign access to allowed lists to	3 Dial list number (0 through 7).
voice terminals	4 Touch Auto Intercom button for voice terminal:
	Steady green on = voice terminal has access to numbers on list
	Green off = voice terminal doesn‘t have access to numbers on list
	5 Touch Message.
To get a printout of an allowed list	1 Touch Message.
	2 Dial	#5.
	3 Dial list number (0 through 7).
	4 Dial 0 #900 and wait for beep.
	5 Touch Message.
To get a printout of voice terminal	1 Touch Message.
access to allowed lists	2 Dial #904 and wait for beep.
	3 Touch Message.
Camp On return interval	1 Touch Message.
	2 Dial # 326.
	3 Dial number of minutes (1 through 5) preferred before calls
	return to originator.
	4 Touch Message.
Centralized Programming	1 Touch Conference.
	2 Touch Auto Intercom button for voice terminal to be programmed.
	3 If red light next to Adm Tel goes off and console rings every 5
	seconds, go on to step 4. If not, wait for light to go off or try
	again later.
	4 Perform programming steps, except for entering and leaving
	programming mode.
	5 Touch Conference twice.
Dialing Timeout for rotary lines	1 Touch Message.
	2 Dial # 317.
	3 Dial number to specify timeout interval:
	0 = 0 seconds
	1 = 4 seconds
	2 = 8 seconds
	3 = 12 seconds
	4 Touch Message.

3-10Button Code Administration Procedures