AT&T feature module 2 system manual Touch-Tone or Rotary Signaling

Touch-Tone or Rotary Signaling

DESCRIPTION	When the MERLIN II system is installed, it is set to send or generate Touch-
	Tone signals. If some of the system’s lines generate rotary pulses, you need
	to identify each of those lines to the system,
	If you are not sure whether lines are Touch-Tone m rotary, perform this test
	at the administrator/attendant console:
	1	Make sure the T/P switch is in the center position.
	2	Touch each line button and dial out.
		If the line is Touch-Tone, you hear tones and the dial tone stops. If the line is rotary, you
		hear tones, but the dial tone is not interrupted.
ADMINISTRATION	If there are rotary lines in the system, enter administration mode and follow
	the appropriate procedure below to identify them.
	With a MERLIN II System Display Console
	1 From the administration menu, touch [Lines], [More], [TchTone] .
	2	Touch each line button until the light next to it shows the appropriate
		code:
		Steady green on = Touch-Tone
		Green off = rotary
	3	Touch Conference to return to the administration menu, or leave
		administration mode.
	With a BIS-34D Console
	1 Touch Message.
	2	Dial # 302.
	3	Touch each line button until the light next to it shows the appropriate
		code:
		Green light on = Touch-Tone dialing
		Green light off = rotary dialing
	4	Touch Message and go on to another procedure, or leave administration
		mode.

2-160MERLIN II System Features