AT&T feature module 2 system manual Attendant Barge-In, Description

To Get Printouts

4 Touch the Auto Intercom button for each voice terminal whose status you want to change until the correct code is showing.

Green light on = voice terminal can access numbers in the list

Green light off = voice terminal cannot access numbers in the list

5 Repeat steps 2 through 4 for each allowed list that you want to assign to voice terminals in your system.

6 Go to step 2 of the procedure below to get printouts, or leave administration mode.

If you have a printer connected to your system, you can get a printout of any of your allowed lists and the voice terminals that can access them.

1 Touch Message.

2 Dial the appropriate code:

To get a printout of an allowed list, dial #5, the list number (0 through 7), and 0 #900.

To get a printout of the voice terminals that can access allowed lists, dial # 904.

3 Touch Message to go on to another procedure, or leave administration mode.

Attendant	Barge-In
DESCRIPTION	Attendants who must contact a person whose voice terminal is busy or has
	Do Not Disturb activated can use Attendant Barge-In to bridge onto the call or
	override DO Not Disturb.
CONSIDERATIONS	● Only attendant positions can use this feature.
	● This feature must be programmed on a button.
	● You cannot use Attendant Barge-In for a Call Distribution Group.
	● If the target voice terminal is in programming mode, you will hear a busy
	signal if you try to use Attendant Barge-In.
	● Attendant Barge-In cannot override Privacy at the target voice terminal
	and cannot be used to bridge onto conference calls involving three voice
	terminals.
	● An Attendant Barge-In call will not be directed to another voice terminal if
	Call Coverage, Call Forwarding, or Follow Me is in effect.
PROGRAMMING	To program an Attendant Barge-In button at an attendant position, label an
	available button, enter programming mode, and follow these steps:
	1 Touch the button you want to program.

2-8MERLIN II System Features