AT&T feature module 2 system manual Attendant Postion Setting, Description Considerations

	2	Dial *25.
	3	Program another feature, or leave programming mode.
HOW TO USE	1 Place a ringing intercom call.
	2	If you hear a busy signal or the person doesn’t answer touch Barge-In.

If a call is in progress, the people hear a tone, then you are bridged onto their call, If Do

Not Disturb is in effect, the person you are calling hears ringing.

Attendant Postion Setting

DESCRIPTION

CONSIDERATIONS

The system administrator must identify the stations that will be attendant positions.

●The system always recognizes the console that is plugged into default station jack 01 (intercom 10) as an attendant position.

●Every fourth analog station jack can be used for an attendant position and no more than two stations on a single analog voice terminal module can be designated as attendant positions.

●A MERLIN II system can have a maximum of eight attendants.

	● If the administrator changes a standard voice terminal to an attendant
	position or voice versa, he or she must reassign lines and features to the
	voice terminal or console.
ADMINISTRATION	Get the Master Planning Form or the Station Configuration Forms, which
	show the stations to be used as attendant positions. Enter administration
	mode, and follow the appropriate procedure, below, to designate attendant
	positions.
	With a MERLIN II System Display Console
	1 From the administration menu, touch these buttons: [System], [Attendants],
	[Position].
	A steady or a flashing green light will appear next to each button for each station that
	either is or can be an attendant position (see Step 2 below). No light goes on next to the
	button for a station that cannot be an attendant position.
	NOTE: If you see the message, “System busy—please wait, ” wait for a
	prompt or try this procedure again later.
	2 To change an attendant position setting, touch the Auto Intercom button
	for the station until the green light next to the button shows the setting
	you want:
	Green light on = this station is an attendant position.
	Green light flashing = this station can be but is not now an attendant position.
	3 Touch [Store] .
	You see the message,“System is Re-starting” and then the administration menu reappears.

MERLIN II System Features 2-9